Displayed Messages - Hotpoint MCX103X Instructions For Use Manual

DISPLAYED MESSAGES

DISPLAYED MESSAGE
REMEDY
GROUND TOO FINE ADJUST MILL!
INSERT WATER SPOUT!
press OK
GROUND TOO FINE ADJUST MILL!
(alternating with)
press OK
(then)
FILL TANK !
EMPTY GROUNDS CONTAINER!
INSERT GROUNDS CONTAINER!
ADD PRE-GROUND COFFEE!
DESCALE!
(alternating with)
MEDIUM CUP STANDARD TASTE
LESS COFFEE !
FILL BEANS CONTAINER!
INSERT INFUSER ASSEMBLY!
CLOSE DOOR !
GENERAL ALARM!
POSSIBLE CAUSE
• The water tank is empty or positioned
incorrectly.
• The grinding is too fine and the coffee
is delivered too slowly.
• The tank has been removed during de-
livery.
• There is air in the hydraulic circuit.
• The grounds container (A4) is too full
or more than 3 days have passed since
you last made coffee (this guarantees
correct hygiene of the machine).
• After cleaning, the grounds container
has not been replaced.
• The "pre-ground coffee" function has
been selected without placing any pre-
ground coffee in the funnel.
• The funnel (A21) is blocked.
• The machine must be descaled.
• Too much coffee has been used.
• The coffee beans have run out.
• The brewing unit has not been repla-
ced after cleaning.
• The service door is open.
• The inside of the appliance is very dirty.
REMEDY
• Fill the tank with water and/or insert it
correctly, pushing it as far as it will go.
• Turn the grinding adjustment knob one
click clockwise towards "7".
• Insert the tank and press the OK icon
(B9). "HOT WATER" is displayed. Hot
water is delivered and the appliance is
once again ready for use.
• Empty the grounds container and
clean, then replace.
Important: when removing the drip
tray, the grounds container MUST be
emptied, even if it is not completely full.
If this is not done, when you make the
next coffees, the grounds container
may fill up more than expected and
clog the machine.
• Open the service door and insert the
grounds container.
• Extract the appliance and place pre-
ground coffee in the funnel.
• Empty the funnel with the help of a
knife as described in the section "Clea-
ning the pre-ground coffee funnel".
• The descaling procedure described in
the "Descaling" section needs to be per-
formed as soon as possible.
• Select a milder taste or reduce the
quantity of pre-ground coffee, then
make the coffee again.
• Fill bean container
• Insert the brewing unit as described in
the section "Cleaning the brewing unit".
• Close the service door.
• Clean the inside of the appliance tho-
roughly, as described in the section
"Cleaning and maintenance".
If the message is still displayed after
cleaning, contact a customer services.
GB
17