Thx ultra2 digital / thx select dolby digital ex /dts es / dolby digital surround receiver, progressive scan universal disc player, system control, 3 chip dlp high definition projector, hd ready plasma monitor, reference control preamplifier/power amplifi (39 pages)
Av receivers / remotes/tuners / home system / multi-zone control amplifier / plasma display / dlp projectors / stereo receiver / power amplifiers / multi-channel super audio cd player / cd player / integrated amplifier / stereo tuner / high definition dig (36 pages)
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
IMPORTANT SAFETY This product was designed and manufactured to meet strict quality and safety standards. There are, however, some installation and operation precautions which you should be particularly aware of. Read Instructions – All the safety and operating instructions should be read before the product is operated. Retain Instructions –...
Page 4
Servicing – Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Damage Requiring Service – Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: When the power-supply cord or plug is damaged.
Page 5
TREBLE TUNE/SEARCH PAUSE ⁄6 ⁄8 CH SKIP CH SKIP ⁄9 TAPE ¤0 PHONO TUNER VOLUME SYSTEM REMOTE CONTROLLER RC4320SR RECEIVER SR4320 MULTI - JOG SPEAKERS DISPLAY OFF CLEAR MEMORY JOG MODE SPEAKERS STANDBY POWER ON/STANDBY PHONES ⁄2 ⁄3 ⁄4 ⁄5...
TABLE OF CONTENTS FEATURES ... 2 ACCESSORIES ... 2 NAMES AND FUNCTIONS ... 3 USING THE REMOTE CONTROL UNIT ... 6 CONNECTIONS ... 7 CONNECTING SPEAKERS ... 7 CONNECTING AUDIO COMPONENTS ... 8 CONNECTING VIDEO COMPONENTS ... 9 CONNECTING REMOTE CONTROL JACKS ... 10 CONNECTING THE ANTENNA TERMINALS ...
FEATURES High quality full discrete power amplifier 80W+80W (8 ohms, 20 Hz – 20 kHz, 0.08% THD) Speaker A/B switching You can switch the speaker A/B via remote control unit. Three A/V inputs (DVD, DSS and VCR) One A/V output (VCR) and one video monitor output Seven audio inputs and three audio outputs Built in PHONO equalizer (MM) Simulcast playback video signal of video source with audio...
NAMES AND FUNCTIONS FRONT PANEL q P OW E R O N / S TA N D B Y s w i t ch a n d STANDBY indicator When this switch is pressed once, the unit turns ON and display appear on the display panel.
DISPLAY a TUNED indicator This indicator illuminates when a station is being received with sufficient signal strength to provide acceptable listening quality. b STEREO indicator This indicator illuminates when an FM station is being tuned in stereo condition. c MEMORY indicator When the MEMORY button is pressed, this indicator blinks for about 5 seconds.
To select the DVD as the input source and play the DVD player. Press the DVD button twice within 2 seconds. The input selector of the SR4320 is switched to DVD and the remote control unit is set for control of the DVD player.
Remote control operational range The distance between the transmitter of the remote control unit and the IR SENSOR of the SR4320 should be less than about 5 meters. If the transmitter is pointed to a direction other than the IR SENSOR or if there is an obstacle between them, remote control may not be possible.
CONNECTIONS CONNECTING SPEAKERS ANTENNA FM (75 Ω) PHONO CDR / MD TAPE AUDIO Connecting speaker wire Strip away approx. 3/8 inch (10 mm) of wire insulation. 10 mm Twist the exposed wire ends very tight to prevent short circuits. Loosen the knob by turning counterclockwise. Insert one bare wire into the hole in the side of each terminal.
CONNECTING AUDIO COMPONENTS The output audio signal from the TAPE OUT jack and the CD-R/MD OUT jack is the sound source currently selected. Tape deck R L R L ANTENNA FM ( 75 Ω ) PHONO PHONO CDR / MD CDR / MD TAPE TAPE...
CONNECTING VIDEO COMPONENTS AUDIO AUDIO ANTENNA FM ( 75 Ω ) PHONO CDR / MD DVD player Notes: • Insert all plugs and connectors securely. Incomplete connections will result in the generation of noise. • Be sure to connect the left and right channels properly. Red connectors are used for the R (right) channel, and white connectors are used for L (left) channel.
CONNECTING REMOTE CONTROL JACKS You can control other Marantz products through this unit with the remote control unit by connecting REMOTE CONTROL terminals on each unit. The signal transmitted from the remote control unit is received by the remote sensor on this unit then the signal is sent to the connected device through this terminal.
CONNECTING THE ANTENNA TERMINALS FM antenna ANTENNA FM (75 Ω) PHONO CDR / MD TAPE AUDIO Assembling the AM loop antenna Release the vinyl tie and take out the connection line. Bend the base part in the reverse direction. Insert the hook at the bottom of the loop part into the slot at the base part.
OPERATION NORMAL PLAYBACK RECEIVER SR4320 MULTI - JOG SPEAKERS DISPLAY OFF CLEAR MEMORY TUNING/PRESET MODE JOG MODE SPEAKERS S-DIRECT SLEEP STANDBY POWER ON/STANDBY PHONES CDR/MD TAPE PHONO MAIN SOURCE POWER POWER MUTE SLEEP DIMMER CLEAR MEMO S-DIRECT F.DIRECT T.MODE P.SCAN SPKR A/B DISP./RDS...
LISTENING TO A DIFFERENT AUDIO SOURCE WHILE WATCHING A VIDEO SOURCE Select one of the following video sources. DVD, DSS or VCR Next, select one of the following audio sources with remote control unit. TUNER, PHONO, CD, TAPE or CDR/MD CHANGING THE BRIGHTNESS OF THE FRONT DISPLAY The display brightness changes in three steps (max, min and off) by...
LISTENING TO THE RADIO MANUAL TUNING SPEAKERS DISPLAY OFF CLEAR MEMORY TUNING/PRESET JOG MODE SPEAKERS S-DIRECT SLEEP CDR/MD TAPE PHONO DIRECTION INPUT BASS TREBLE TUNE/SEARCH PAUSE CH SKIP CH SKIP TAPE PHONO TUNER VOLUME SYSTEM REMOTE CONTROLLER RC4320SR To select the tuner as the source, press the TUNER button on the front panel or the TUNER button on the remote control unit.
PRESET TUNING With this unit you can preset up to 30 FM/AM stations in any order. For each station, you can memorize the frequency and reception mode if desired. 2, 4 SPEAKERS DISPLAY OFF CLEAR MEMORY TUNING/PRESET JOG MODE SPEAKERS S-DIRECT SLEEP CDR/MD...
Page 21
3 seconds. The left most column of the station name indicator flashes, indicating the character entry ready status. [Operation (Using the SR4320)] When you press the TUNING/PRESET and numeric characters will be displayed in the following order: A →...
If your trouble cannot be recovered with the remedy actions listed in the following table, malfunction of the internal circuitry is suspected; immediately unplug the power cable and contact your dealer, nearest Marantz distributor or the Marantz Service Center in your country. POSSIBLE CAUSE • The AC input cord is disconnected.
Page 23
The memory functions are backed up for up to about one week. Note: First of all keep SR4320 Standby or Powered-on more than 6 hours, to sufficient time for memory hack up. HOW TO RESET THE UNIT Should the operation or display seem to be abnormal, reset the unit with the following procedure.
Need help?
Do you have a question about the SR4320 and is the answer not in the manual?
Questions and answers