Before You Begin Scanning; Installing The Magicscan Software; Formatting The Sd Card; Docking The Wand - GPX PS803 v827-01 User Manual

Before You Begin Scanning

Installing the MagicScan Software

Requires Windows XP SP2 or higher.
It is strongly recommended to install the MagicScan software before using the product.
1. Insert the included CD and follow the prompts as they guide you through installation.

Formatting the SD Card

It is recommended to format the included 4GB Micro SD card before use. Please follow the formatting instructions below.
1. Press and hold the Power/Menu button to power the unit on.
2. Press the Power/Menu button to enter the setup menu.
3. Use the Arrow and Selection/Scan buttons to locate and select Format.
4. Use the Arrow buttons to scroll all the way down to the bottom of the menu and select the check mark
) , then press the Selection/Scan button to confirm the command.
(

Docking the Wand

1. Set the right side of the scanning wand in place and carefully align the left side with the slot on the dock,
paying careful attention to the placement of the Mini-USB connector and making sure the scanning wand is
facing the correct way. Gently lower the left side into place. Note: Do not force the scanning wand into the dock
or damage may occur.
2. Once attached, it will click firmly into place.
3. To remove the wand, press the Release button and gently lift the wand upward from the left.
Press Release Lever
8
Dock and Wand successfully attached