Gcs Assistant Software Operation; Gcs Assistant Software Download And Upgrade Operation; Setting And Using Gcs Assistant Software - Wingsland Minivet User Manual

6 GCS Assistant Software Operation

6-1

GCS Assistant Software Download and Upgrade Operation

WINGSLAND_GCS Software has some very practical functionality, such as:
Firmware Upgrade, Neutral Point Calibration of Remote Controller, Flight Simulator Operation, etc.
(1)
Prepare the Aircraft and Software
Remove all propellers.
Download GCS Assistant Software to PC from the Windgland website: www.szsungreeen.com.
Unzip the zip file and run the WINGSLAND_GCS software.
Connected the Aircraft USB port (close the Aircraft Battery) to PC via USB cable.
Do not power on the aircraft, to avoid damaging the USB port of PC.
Power on the Remote Controller.
(2)
GCS Assistant Flight Firmware Upgrade
Obtain the latest Firmware from Wingsland website: www.
szsungreeen.com or Windsland authorized dealer, save to
PC. Click the "Firmware Choice" icon on "Firmware" interf
-ace to choose the latest Firmware file.
Click the "Start Updating" icon to upgrade the latest Firmw
-are. Do not disconnect until the upgrade is finished.
6-2

Setting and Using GCS Assistant Software

(1)
Calibrate the Stick Neutral.
Run GCS Assistant software. Choose the "Remoter
Controller" icon on the "State" interface.
Click the "Remote Controller Calibration" icon and P
-rogram Calibration. Operate the Remote Controller
according to the prompt, until Calibration finished.
Remote Controller Calibration
Click the "YES" icon to
start calibration.
Figure 1
Push Left and Right stick to
the central position, then c
-lick "YES" icon.
After clicking "YES" icon, rota
te Left and Right stick along th
-e maximum radius(Figure 1)
until the below window closes.
If power on the motors during
this process, maintain the Thr
-ottle stick on the lowest posit
-ion until the aircraft motors lo
-cked.
18
1
Firmware Status
ID
SN
FW Ver
2
Select the Firmware file Start Update
1
Firmware Status
Attitude
Remote Control
2
RC Date
Stabilized mode Hovering mode Return to Launch
Hotspot circle mode Standard Care free mode
You will Calibrate your RC, select Yes
to start, select No exit the process.
NO
Please put all the sticks in the middle
position. Then Click the OK button.
Circle the sticks to max radius after
clicking OK button within 2s.
Copyright@2015 WINGSLAND All Right Reserved
English
English
3
Calibration RC
3D
Yes
Yes
Yes