Child Lock Out; Adjusting Oven Temperature; Service Tones And Codes - Amana ARGS7650 Service Manual

Programming Instructions
!
To avoid risk of personal injury, do not touch oven
vents or areas around vents during self-cleaning.
These areas can become hot enough to cause burns.
1. Prepare oven for self-cleaning.
• Remove oven racks and all cooking utensils from
oven.
• Clean excess spills from oven interior.
• Remove items from range top and backguard.
These areas can become hot during self-cleaning
cycle.
2. Press CLEAN pad.
• "CLEAN", "TIME", and "----" display.
3. Press or pad until desired amount of cleaning
time is displayed.
• "3:00" displays when
• Increase or decrease cleaning time in 5 minute
increments.
• Clean can be set from 2 to 4 hours. Minimum
recommended cleaning time is 3 hours.
4. Press STOP TIME pad.
5. Press or pad until desired stopping time
appears in display.
• Starting time is automatically calculated based on
amount of cleaning time and stop time.
• "DELAY", "CLEAN, "STOP", "TIME", "CLEAN",
and "LOCK" display. "LOCK" flashes in display
when automatic door latch is locking.
• To view remaining cleaning time, press and hold
CLEAN pad.
• To view calculated stop time, press STOP TIME
pad.
• When cleaning time has elapsed, oven
automatically turns off and display returns to
time-of-day.
• When oven cools to a safe temperature, door
latch opens and "LOCK" light flashes while
opening. After door latch opens, "LOCK" light no
longer displays and door can be opened.
Interrupt Self-Clean Cycle
1. Press OVEN CANCEL pad.
2. When oven has cooled to a safe temperature, door
will unlock and can be opened.
CAUTION
or is pressed.

Child Lock Out

This feature disables oven control. Surface elements can
be used while child lock out is on.
1. Press and hold BAKE and CLOCK pads
simultaneously.
• "OFF" displays briefly.
2. Repeat step 1 to cancel child lock.

Adjusting Oven Temperature

Oven temperature has been factory calibrated and
tested.
If oven consistently over or under cooks food, adjust
temperature offset. Oven temperature can be increased
or decreased 35°F. To avoid over adjusting oven, move
temperature 5°F each time.
1. Push BAKE pad.
2. Press pad until an oven temperature greater than
500°F shows in display.
3. Immediately push and hold, approximately
5 seconds, BAKE button until "00" appears in
display.
4. Press or pad knob to adjust oven
temperature.
• To increase oven temperature (for a hotter oven),
Press or
appears in display.
• To decrease oven temperature (for a cooler oven),
Press or
appears in display.
5. Press OVEN CANCEL pad to save adjustment.
• Setting is saved if power fails or is disconnected.

Service Tones and Codes

Electronic range control has a self-diagnostic system.
Self-diagnostic system sounds a series of short, rapid
beeps and shows a "F-code" in display when there is a
problem. When electronic range control signals a
problem, follow steps listed below.
1. Record "F-code" shown.
• F1—pad malfunction
• F2—high oven temperature
• F3—temperature sensor malfunction
• F4—temperature circuit malfunction
• F5—control malfunction
• F7—door lock malfunction
• F9—door lock or oven door not completely closed
Door—door not closed/malfuction in door switch
circuit or latch switch
"Lock"–flashing—malfuction in door switch or lock
switch ciruit
2. Press TIMER ON/OFF pad or disconnect electrical
supply.
• Disconnecting electrical supply eliminates
"F-code". If failure continues, contact an authorized
servicer.
3. Contact an authorized servicer to check range.
B–5
pad until a positive number
pad until a negative number
RS2310002 Rev. 1