Silvercrest USB 2.0 HUB Operating Instructions

■ GB / IE
Introduction
Congratulations on the purchase of your new appliance.
You have clearly decided in favour of a high-quality
product. These operating instructions are a part of this
product. They contain important information in regard
to safety, use and disposal. Before using the product,
familiarise yourself with all operating and safety instruc-
tions. Use this appliance only as described and only
for the specifi ed areas of application. Retain these
instructions for future reference. In addition, pass these
operating instructions on to whoever might acquire
the appliance at a future date.
Safety instructions
■ Before use, check the appliance for visible external
damage. Do not operate a damaged appliance or
one that has been dropped.
■ Should the cable or connections be damaged,
arrange to have them exchanged by an author-
ised specialist or the Customer Service.
■ Handle the appliance with care. It can be damaged
USB 2.0 HUB SUHK 10 A1 by knocks, impacts or a fall from a low height.
■ Do not make any unauthorised modifi cations or
alterations to the appliance.
USB 2.0 HUB ■ Protect the appliance against moisture and liquid
Operating instructions
penetration.
■ Do not operate the appliance close to open
USB-2.0-HUB
fl ames (e.g. candles).
Betjeningsvejledning
■ Avoid direct solar radiation.
USB-2.0-HUB
Scope of delivery
Bedienungsanleitung
▯ Card Reader with 3-port USB hub
▯ USB cable (Type A to Mini-B)
▯ This operating manual
IAN 78821
NOTICE Compatible memory cards*
► Check the contents to ensure that everything
micro SD
is available and for signs of visible damage.
► If the contents are not complete, or are dam-
aged due to defective packaging or through up to V. 3.0 (32GB)
SD
transportation, contact the Service Hotline
(see chapter Service).
SDHC
Appliance description
USB port
up to V. 1.43 (8GB)
M2
USB port
Slot for M2
Mini USB Connection
xD
Slot for MS, MS PRO, MS PRO Duo
MS up to V. 1.43 (4GB)
Slot for Micro SD
MS PRO: up to V. 1.05
MS / MS
Slot for SD, SDHC, MMC, RS-MMC
(4GB) MS PRO Duo: up
PRO / MS PRO Duo
Slot for XD
Operation LED
MMC
USB port
RS-MMC up to V.4.4 (512MB)
USB cable
* All brand names mentioned herein are simply for
identifi cation purposes and may be trademarks of
Technical data
their respective owners.
USB-Specifi cations Version 2.0
Notes on the Declaration of
Data transfer rate up to 480 Mbit/s
Conformity
5 V
Voltage supply This appliance complies with, in regard to conformity
(Bus-Powered-Mode)
with essential requirements and other relevant provi-
USB output voltage 5 V +/- 5%
sions, the RoHS Directive 2011/65/EU.
each connection 100 mA The complete original declaration of conformity can
USB output current
be obtained from the importer.
Overall, max. 300 mA
Dimensions approx. 82 x 54 x 10 mm
First use
approx. 70 g
Weight You can simply plug the card reader into a USB port
(including cable)
on your computer. The required drivers are installed
Operating temperature 15°C - 35°C automatically on connection.
Relative humidity: < 75 % Please note that when you install the card reader no
external device may be connected.
USB 2.0 compatible
port, Windows XP / Proceed as follows:
System Requirements
Vista / 7 / Mac OS X
♦ Switch the PC on and wait until the operating
v10.4 or higher
system has booted.
- 1 - - 2 - - 3 -
♦ Connect the supplied USB cable with the Mini- Disposal
USB port of the card reader.
Do not dispose of the appliance in
your normal domestic waste. This
♦ Connect the other end of the USB cable with
product is subject to the provisions
a free USB port on your computer. After the oper-
ating system has installed the required drivers, of European Directive 2002/96/EC-WEEE
the card reader is ready for use. The Operation (Waste Electrical and Electronic Equipment).
LED lights up in blue. Dispose of the appliance through an approved disposal
centre or at your community waste facility. Please
♦ You can now connect your memory cards and
observe the currently applicable regulations. In case
USB fl ash drives/USB peripherals (such as printers,
of doubt, please contact your waste disposal centre.
scanners, etc.) to the card reader. The storage
media is indicated as a removable medium in
Warranty
Windows Explorer.
The warranty for this appliance is for 3 years from the
up to V. 1.2 (2GB)
CAUTION date of purchase. This appliance has been manufac-
tured with care and meticulously examined before
► Ensure that the data transfer is complete before
delivery.
removing the memory card or USB fl ash drive
Please retain your receipt as proof of purchase. In
from the card reader. Otherwise a data loss
the event of a warranty claim, please contact our
cannot be excluded.
to V.1.43 (8GB)
Customer Service department by telephone. Only in
this way can a post-free despatch for your goods be
up to V.4.4 (2GB) NOTE
assured.
► A driver installation may be required for the
connected USB peripherals. You will receive NOTE
the driver with the purchase of the appliance
► The warranty covers only claims for material
or from the appliance manufacturer.
and manufacturing defects, not for transport
damage, wear and tear or for damage to fragile
Cleaning
components, e.g. switches or batteries.
CAUTION
This appliance is intended solely for private domestic
► Ensure that, when cleaning it, no moisture can use, not for commercial applications. If this product
penetrate into the appliance, so as to avoid has been subjected to improper or inappropriate
irreparable damage to it. handling, abuse, or modifi cations not carried out by
one of our authorised service centres, the warranty
► Do not use chemical or abrasive cleaning
will be considered void.
agents. These could damage the housing.
Your statutory rights are not restricted in any way by
♦ Clean the appliance with a soft, dry cloth.
this warranty. The warranty period is not extended by
repairs made under the warranty. This applies also to
Storage
replaced and repaired parts.
Store the appliance in a clean, dry place away from
Damages and defects extant at the time of purchase
direct sunlight.
must be reported immediately after unpacking, resp.
no later than two days after the date of purchase.
Repairs made after the lapse of the warranty period
are subject to charge.
- 4 - - 5 -
■ DK
Service Indledning
BEMÆRK
Til lykke med købet af dit nyt elapparat.
Service Great Britain
► Kontrollér, at alle dele er leveret med og ikke
Tel.: 0871 5000 720 (£ 0.10/Min.) Med dit køb har du valgt et produkt af høj kvalitet.
har synlige skader.
Betjeningsvejledningen er del af dette produkt. Den
E-Mail: kompernass@lidl.co.uk
► Hvis der mangler dele eller nogen af delene
indeholder vigtige anvisninger til sikker brug og bort-
IAN 78821 er beskadigede som følge af defekt emballage
skaff else. Sæt dig ind i produktet med alle betjenings-
eller transporten, bedes du henvende dig til
Service Ireland og sikkerhedsanvisninger, før du bruger det første
service-hotline (se kapitlet Service).
Tel.: 1890 930 034 gang. Brug kun produktet som beskrevet og kun til
(0,08 EUR/Min., (peak)) de angivne anvendelsesområder. Opbevar denne
Beskrivelse af produktet
(0,06 EUR/Min., (off peak)) vejledning omhyggeligt. Lad vejledningen følge med
USB-tilslutning
produktet, hvis du giver det videre til andre.
E-Mail: kompernass@lidl.ie
USB-tilslutning
IAN 78821
Sikkerhedsanvisninger
Slot til M2
■ Kontrollér produktet for udvendige, synlige skader, Mini USB-tilslutning
Importer
før du bruger det. Brug aldrig produktet, hvis det
Slot til MS, MS PRO, MS PRO Duo
KOMPERNASS GMBH
har skader eller falder ned.
Slot til Micro SD
BURGSTRASSE 21
■ Hvis kabler eller tilslutninger beskadiges, skal
Slot til SD, SDHC, MMC, RS-MMC
44867 BOCHUM, GERMANY
de udskiftes af en autoriseret reparatør eller af
Slot til XD
www.kompernass.com kundeservice.
Drifts-LED
■ Behandl produktet forsigtigt. Det kan beskadiges
USB-tilslutning
af stød, slag eller fald selv fra mindre højder.
USB-kabel
■ Foretag ikke ombygninger eller ændringer af
produktet. Tekniske data
■ Beskyt produktet mod fugt og indtrængende væsker.
USB-specifi kationer
■ Brug ikke produktet i nærheden af åben ild
Dataoverførselshastighed
(f.eks. stearinlys).
Spændingsforsyning
■ Undgå direkte solstråler.
Udgangsspænding USB
Leverede dele
▯ Kortlæser med 3-x USB-hub
Udgangsstrøm USB
▯ USB-kabel (type A til mini-B)
▯ Denne betjeningsvejledning Mål
Vægt
Driftstemperatur
Luftfugtighed
Systemforudsætninger
- 6 - - 7 -
Kompatible lagerkort*
microSD
indtil V. 3.0 (32GB)
SD
SDHC
indtil V. 1.43 (8GB)
M2
indtil V. 1.2 (2GB)
xD
MS: indtil V. 1.43 (4GB)
MS PRO: indtil V. 1.05
MS / MS
(4GB) / MS PRO Duo:
PRO/MS PRO Duo
indtil V.1.43 (8GB)
MMC indtil V.4.4 (2GB)
RS-MMC indtil V.4.4 (512MB)
* Alle mærkenavne, som nævnes her, bruges kun til
identifi kation og er ejernes handelsmærker.
Informationer til EU-overens-
Version 2.0
stemmelseserklæringen
op til 480 Mbit/s
Dette produkt er i overensstemmelse med de grund-
5 V
læggende krav og øvrige relevante forskrifter i
(Bus-Powered-Modus)
RoHS-direktivet 2011/65/EU.
5 V +/- 5 %
Den komplette, originale overensstemmelseserklæring
kan rekvireres hos importøren.
pr. tilslutning 100 mA
i alt maks. 300 mA
Første brug
ca. 82 x 54 x 10 mm
Kortlæseren kan sluttes til din computers USB-tilslutning.
ca. 70 g (inkl. kabel) De nødvendige drivere installeres automatisk ved tilslut-
ningen. Sørg for, at der ikke er tilsluttet slutapparater
15°C - 35°C
ved installation af kortlæseren.
< 75 %
Gå frem på følgende måde:
USB 2.0-kompatibel til-
♦ Tænd for pc'en, og vent, til den er startet op.
slutning, Windows XP /
Vista / 7 / Mac OS X ♦ Slut det medfølgende USB-kabel til kortlæserens
mini-USB-tilslutning .
10.4 eller højere
- 8 - - 9 -