Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Sarabec Loop System LA240
Summary of Contents for Sarabec Loop System LA240
- Page 1 Connevans.info Solutions to improve the quality of life This product may be purchased from Connevans Limited DeafEquipment.co.uk secure online store at www.DeafEquipment.co.uk...
- Page 2 Loop System LA240 User manual A C C E S S T O S O U N D...
-
Page 3: Quick Setup
Introduction The LA240 Loop System provides a practical solution for hearing aid users to listen more easily to their TV or Audio equipment via the “T” or “Loop” program of their hearing aid. With no direct connection between the user and a TV or Audio equipment the user is able to move freely within the looped area and listen comfortably to a TV or audio equipment without the distractions of normal listening. -
Page 4: Important Safety Instructions
Important Safety Instructions The manufacturer cannot be held responsible for damage which is caused by not using this Loop System in compliance with these safety instructions. IF IN ANY DOUBT SEEK EXPERT ADVICE 1. Read and follow these instructions taking note of any warnings. Keep these instructions for future reference. 2. -
Page 5: Product Overview
Product Overview An enhanced microprocessor controlled loop amplifier with outstanding sound quality designed to be used with modern audio and video products to transmit the sound direct to your hearing aid. Your hearing aid must be switched to the “T” or Loop function to use the loop system. - Page 6 Setting Up The loop system is supplied ready for use with the following items • Loop Amplifier with stand. • Power Supply with lead and Mains lead with fitted plug. • Digital audio optical TOSlink and coaxial leads. • Analogue audio lead kit : 1.2m phono - phono lead, SCART - phono and 3.5mm stereo jack - phono adaptors. •...
- Page 7 Connect Loop Cable or Loop Pad to the amplifier When the loop cable connector (11) buttons are pushed in a hole will appear. Push the bare wire into the hole. Ensure that only the bare wire and not the plastic insulation goes into the hole, then release the button to lock the cable in place.
-
Page 8: Operation
Power Plug the power supply lead into the socket (10) on the rear of the amplifier. Connect the mains lead to the power supply and then plug into a mains outlet. Switch on the power at the outlet. This amplifier may also be used with DC power supplies directly connected to the amplifier such as those found in buses and coaches. -
Page 9: Digital Audio
Tone control (2) Use to vary the tone of the signal. Turned in the clockwise direction the higher frequencies will be emphasised and in the anti-clockwise direction the lower frequencies will be emphasised. As the tone control is moved the blue light will travel around the control indicating the tone position in use. - Page 10 This page is intentionally blank...
-
Page 11: Distorted Sound
Problems and Cures Symptom Possible cause and remedy • No sound Re check all connections • Check diagrams • Amplifier not switched on. Switch on at mains socket. Press mains switch. Check blue light is on • Microphone or audio source not connected or selected •... -
Page 12: Specifications
) single core PVC insulated cable. Min cable length 11m = 0.5 Ohms Indicators • Blue/Red LEDs Sarabec Ltd declares that the LA240 complies with all relevant EU directives. The full EU declaration of conformance for the LA240 is available from Sarabec Ltd. - Page 13 Sarabec Ltd 15 High Force Road Middlesbrough United Kingdom TS2 1RH Telephone : 01642 247789 Fax : 01642 230827 email : mail@sarabec.co.uk web : www.sarabec.com LA240 Issue 1 GB May 2015...
Need help?
Do you have a question about the Loop System LA240 and is the answer not in the manual?
Questions and answers