Table of Contents
Advertisement
Door removal
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury. If your front door is too narrow to get
the refrigerator into the house, remove the refrigerator
doors and pass the appliance through laterally.
Remove the lower cover by loosening all the screws. Then push in the feed water tube
Remove lower
while depressing the connector , as shown in the illustration on the right.
cover and then
feed water tube
NOTE
•
If a tube end is deformed or abraded, trim the end with sharp knife until perfectly round.
1) Remove the hinge cover by loosening
Remove the
the screws. Then separate all
freezer
connection wires except for the earth.
compartment
door
2) Remove the keeper by rotating it counter clockwise
( ) and then lifting the upper hinge up ( ).
NOTE
•
When removing the upper hinge, be careful that
the door does not fall forwards.
3) Remove the freezer compartment door by lifting it
upward. The door should be lifted high enough for the
feed water pipe tube to be completely pulled out.
NOTE
•
If you have removed the refrigerator compartment
door to pass the appliance through an access door, lay
the door down, but be careful not to damage the feed
water pipe tube.
Remove the
1) Loosen the hinge cover screws and
remove the cover. Remove connection
refrigerator
wires, if any, except for the earth line.
compartment
door
8
Electric Shock Hazard
Applicable to No Plumbing
Ice & Water Model only
Feed water tube
Lower cover
Feed water tube
Hinge cover
Upper hinge
Lower hinge
Installation
Connection
wires
Upper hinge
Keeper
Engough for
water feed pipe
tube to be completely
pulled out
Connection
wires
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GSL545NSQV and is the answer not in the manual?
Questions and answers
How to defrost my freezer section so that I can unblock jammed ice dispenser
To defrost the freezer section of an LG GSL545NSQV to unblock the ice dispenser, follow these steps:
1. Remove the Ice Storage Bin – Take out the ice bin from the freezer.
2. Thaw the Ice – If ice has melted and refrozen around the auger due to infrequent use, temperature fluctuations, or power outages, allow the ice to melt.
3. Clean and Dry – Once thawed, clean the bin, wipe it dry, and ensure no remaining ice buildup.
4. Replace the Bin – Put the ice storage bin back in its proper position.
5. Test the Dispenser – After new ice is made, check if the dispenser operates correctly.
This should resolve any blockage in the ice dispenser.
This answer is automatically generated