Irc Programming; Setting The Machine Numbers - Master And Satellite - Sharp ER-A770 Instruction Manual

Hide thumbs Also See for ER-A770:

Table of Contents

IRC Programming

First, turn on the machines in the IRC system and place them in the PGM2 mode. The

programming procedures for both the master and satellites will be explained below.

1. Setting the machine numbers — master and satellite

It is necessary to insure that each terminal has an assigned machine number to the master and

satellites prior to further IRC programming.

NOTE

In an IRC network, each machine number must be unique.

Do not use the same machine number for more than one machine.

Select "PGM2 MODE" from the mode selection menu

and press the [ENTER] key to enter the PGM2 mode.

Select "SETTING" and press the [ENTER] key.

Select "TERMINAL" and press the [ENTER] key.

Select "MACHINE#" from the REGISTER menu and

press the [ENTER] key.

Enter a machine number and press the [ENTER] key.

Machine number: up to 6 digits (0 - 999999)

Repeat steps 1 to 4 for all machines in the IRC

system.

Table of Contents