Sharp LC-46D65E/RU Service Manual page 33

13. Upgrading the software
1. Turn off the AC power (Unplug the AC power cord).
2. Insert the upgrading USB flash memory for upgrade into the service slot.
3. While holding down the power button, plug in the AC power cord of the main unit to turn on the power.
4. Upgrade begins automatically.
After the set starts, the upgrade screen like the figure below is displayed.
<SYSTEM UPGRADE>
System Version: E0708021
STATUS
UPDATING. . .
5. If any of the procedures fails, the following upgrade failure screen shows up. For the failing procedure, the "NG" marking turns red.
NOTE: In such case, try to upgrade the software again. If it still fails, the hardware may be in trouble.
<SYSTEM UPGRADE>
System Version: E0708021
STATUS
UPDATING. . .
BANK 1
30%
BANK 2
0%
BANK 1
100%
OK
BANK 2
44%
3 – 15
LC-46D65E/RU