How To Program - Hamilton Beach FlexBrew 49965A User Instructions

How to Program

1
For the first time you program, press and hold PROG button for 3 seconds until "19:99" flashes on display.
While continuing to hold the PROG button, press the
according to "How to Set the Time for the First Time" on page 7.
4
Press and release PROG button
again to set autostart.
8
(After the Time Has Been Set)
2
button. "12:00" will flash on display. Set time
5
3
The blue light on the side of the
PROG button will illuminate to
indicate the unit will automatically
start at your desired time. After
the program autostart time has
been set, the autostart sequence
can be toggled on/off by pressing
the PROG button for less then 1
second. To review the autostart
time, press the PROG button
and hold for 3 seconds. After the
initial program setting, time will
default to the last programmed
autostart time set.
NOTES:
• Always place either the single-
serve pack holder or grounds
brew basket in drawer with
every brew.
• Once in PROG mode, cup size
and brew strength cannot be
changed until PROG mode has
been turned off by pressing the
PROG button.
• This unit will automatically
brew on the same settings as
the last brew. Always check
display and change settings
when necessary.
• Use only FRESH COLD water
in the water reservoir.
• Never reheat coffee with this
product.
• Place appropriate size cup or
travel mug on the cup rest.
• For travel mugs, the drip tray
can be removed and the travel
mug can be placed directly on
the cup rest.
• Always add a new single-
serve pack or grounds before
brewing.