Kranzle K115 Operating Manual
  1. Manuals
  2. Brands
  3. Kranzle Manuals
  4. Pressure Washer
  5. K115
  6. Operating manual
Kranzle K115 Operating Manual

Kranzle K115 Operating Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

GB
High Pressure Cleaners
K
K
K
K

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the K115 and is the answer not in the manual?

Questions and answers

Related Manuals for Kranzle K115

Summary of Contents for Kranzle K115

  • Page 1 High Pressure Cleaners...
  • Page 2 Description Dear Customer We would like to congratulate you on your new high pressure cleaner with integrated undercarriage and integrated hose drum and to thank you for the purchase. To ease your introduction to the use of the cleaner, we have provided the following pages of explanations, tips and hints, which we ask you to read before using for the first time.
  • Page 3 Description Water 400 V 230 V Construction The KRÄNZLE 115 + 125 + 135 + 155 - high pressure cleaners are mobile machines. The design can be seen from the diagram. Item 1 Water inlet connection with filter 6 High pressure injector for 2 Suction hose with filter (special cleaning agents accessory) Order no.

  • Page 4: Water And Cleaning System

    Description Water and Cleaning System Water can be connected at mains pressure to the high pressure pump or it can be sucked directly from a storage tank. The water is then forced under pressure by the high pressure pump to the lance. The high pressure jet is formed by the nozzle at the end of the lance.

  • Page 5: Motor Protection Switch

    Description Motor protection switch The motor is protected from overload by a motor protection switch, which automatically cuts out the motor in the event of overload. However should the switch trip frequently, the cause of the malfunction should be located and rectified (see page 6).

  • Page 6: Electrical Connection

    Description Electrical connection The machine is supplied with an electrical power cord with plug. The mains plug must be fitted to a standard grounded socket with a 30mA residual current operated device. The socket must be protected with a 16A delay action fuse on the mains side. KRÄNZLE 115, 125, and 135 - 230 Volt 50 Hz KRÄNZLE 155 - 400 Volt 50 Hz (phase-sequence not significant)

  • Page 7: Water Connection

    Description Water connection: Please check that the high pressure cleaner has available the quantity of water specified on page 2 (techn. specs.) (Litres per minute) . Test: Allow the water supply hose to run for 1 minute into a bucket. The received quantity of water must be at least the quantity given on page 2 !!! Lack of water causes fast wear on seals (no warranty)

  • Page 8: High Pressure Hose And Spray Device

    Description Brief operating instructions are fitted to the machine. Numbers 1-6. When operating your high pressure cleaner pay attention that it is in a horizontal position. 1. Connect the high pressure hose with spray gun and machine. 2. Connect to suitable water supply. 3.

  • Page 9: Safety Notes

    Always aim the underbody lance. Note when using an angled underbody lance, like for example lance No. 41075, that there is a certain amount of torque in the recoil. (K115: 22 Nm K125: 24 Nm K135: 26 Nm K155: 27 Nm)
  • Page 10 This is what you’ve purchased: 1. Spray lance with regulator and high pressure nozzle, flat spray 25045 2. Spray gun with insulated pistol grip and screw connection 3. KRÄNZLE - High pressure cleaners 115, 125, 135 or 155 4. High pressure hose 10 m with 5.
  • Page 11 How to assemble and furnish your high pressure cleaner Put high Pressure clea- ner into upright position. Insert handle from above and fasten with 2 screws from underneath. Suspension for dirt killer (special accessory) Cable Receptacle High pressure hose for spray Receptacle for lance...

  • Page 12: Preparation For Use

    Preparation for use 1 . Put high pressure cleaner Do not replace the plug ! into horizontal position! THE HIGH PRESSURE CLEANER IS ONLY TO BE OPERATED IN HORIZONTAL POSITION ! 2. Connect the high pressure lance to the spray gun. 3 .
  • Page 13 Preparation for use 4 . The machine can be connected to a pressurised water line with cold or 60°C hot water (see page 2). Ensure that the water supply is clean when sucking from external sources. The hose cross section must be at least 1/2”...

  • Page 14: Adjusting The Pressure

    Preparation for use Adjusting the pressure This is accomplished by turning the handwheel. The default setting is maximum pressure. When using cleansing agents: Unwind HP-hose completely. Place chemical filter no. 5 in the reservoir with the cleansing agent. Turn on Vario- Jet No.4 to to enable the injector to induct the cleansing agent.
  • Page 15 This is prohibited ! Never allow children to use the high pressure clea- ner ! Never direct the water jet at the machine itself ! Never direct the water jet at a power socket !
  • Page 16 This is prohibited ! Never direct the water jet at people or animals ! Do not damage the power cord or repair it incorrectly ! Never pull the high pressure hose if it has formed kinks or “nooses”! Never pull the hose over sharp edges !
  • Page 17 Additional KRÄNZLE-accessories for ... Rotary scrubbing brush Order No. 41050 1 Drain and pipe clean- ing hose 8 m - Order No. 41051 15 m - Order No. 41058 Underbody lance, new Order No. 41075 1 Sandblaster Order No. 41068 1 Flat brush Order No.
  • Page 18 ... for further combination possibilities Car cleaning, glass, caravan, boat etc. rotary washing brush with 40 cm exten- sion and ST 30 nipple M 22 x 1,5 Cleaning pipes, channels and drains: pipe cleaning hose with KN nozzle and ST 30 nipple M 22 x 1,5 Underbody cleaning of cars, trailers and equipment: lance 90 cm with high pressure nozzle and ST 30 nipple M 22 x 1,5.
  • Page 19 Small repairs - Do it yourself! You only get a weak flow of water or no water at all! The pressure gauge shows a 10% higher pressure than the working pres The injector may be dirty and Now turn on the water you should and you should get a first...

  • Page 20: Small Repairs

    Small repairs - The nozzle is blocked! No water but the gauge shows full pressure ! You should now have a but if you Rinse the hose powerful stream of only get a few through first. water, drops from the lance remove the lance and clean Using the flat spray lance you the nozzle.

  • Page 21: Do-It-Yourself

    - Do it yourself! Nozzle dirty or sticky! Pressure gauge does not show full pressure. The high-pressure Water comes out in spurts. hose vibrates. If you do not use the high-pressure cleaner for some time the valves can stick When a valve is blocked, the gauge or the high shows little...
  • Page 22 Small repairs - Do it yourself! Stopping leaks from hose or gun After closing the gun the manometer shows full pressure ! The pressure regulator switches on and off contunuously! If the Pull out the First manometer power plug! disconnect shows full the hose! pressure,...
  • Page 23 Trigger gun with lance Ersatzteilliste Pistole mit Lanze Description Qty. Ord.-No Rohranschlussteil R1/4“ 12.125 incl. Pos. 3, 4, 21 Sc heibe 5,3 DIN9021 50.152 Abzug-Hebel kpl. 12.144 1 Mutter M4 12.138 Rohr kunststoffumspritzt bds. R 1/4" AG 1 15.004 2 Überwurfmutter ST 30 M22 x 1,5 IG 13.276 1 Außen-Sechskant-Nippel R 1/4"...

  • Page 24: Complete Assembly

    Complete assembly...
  • Page 25 Spare parts list KRÄNZLE 115 / 125 / 135 / 155 Complete assembly Description Qty. Ord.-No Motor WECHSELSTROM für K 115 43.448 Motor WECHSELSTROM für K 125 43.400 Motor WECHSELSTROM für K 135 43.302 Motor DREHSTROM für K 155 43.327 Motoren jeweils komplett mit Ölgehäuse und Lüfterrad ohne Schalter Gehäusehälfte rechts...
  • Page 26 Valve housing 18 mm...
  • Page 27 Spare parts list KRÄNZLE 115 / 125 / 135 / 155 Valve housing APG for plunger diameter 18 mm Description Qty. Ord.-No Ventilgehäuse 43.435 Zwischenring 18 mm 41.015 2 Ventilstopfen 41.714 O-Ring 15 x 1,5 42.104 Dichtstopfen M 10 x 1 43.043 O-Ring 6 x 3 14.121...
  • Page 28 Transmission unit 18 mm...
  • Page 29 Gehäuseplatte für 18 mm Plunger 41.020 2 Öldichtung 18 x 28 x 7 41.031 O-Ring Viton 88 x 2 41.021 1 Plungerfeder 41.033 Federdruckscheibe 18 mm 41.034 Plunger 18 mm 41.032 1 Sprengring 18 mm 41.035 Taumelscheibe 11,0° bei Kränzle 115 Wechselstrom 46.542-11,0 Taumelscheibe 11,5°...
  • Page 30 A. C. motor...
  • Page 31 Spare parts list KRÄNZLE 115, 125, 135 A. C. motor Description Qty. Ord.-No Ölgehäuse für AP 43.314 Motorgehäuse mit Stator Wechselstrom für Kränzle 115 / 12 5 43.400 9 Motorgehäuse mit Stator Wechselstrom für Kränzle 135 43.315 Rotor mit Motorwelle 43.316 Passfeder 6 x 6 x 20 41.483 1...
  • Page 32 Three-phase current motor...
  • Page 33 Spare parts list KRÄNZLE 155 Three-phase current motor Description Qty. Ord.-No Ölgehäuse für AP 43.314 Motorgehäuse mit Stator Drehstrom 43.324 Rotor mit Motorwelle 43.316 Passfeder 6 x 6 x 20 41.483 1 Rillenkugellager 6205 - 2Z 43.317 Kegelrollenlager 31304 40.472 Toleranzhülse 43.330 1 Öldichtung 25 x 35 x 7...
  • Page 34 Spare parts list KRÄNZLE 115, 125, 135 155 Dirtkiller with lance (special accessory)

  • Page 35: Wiring Diagram

    Wiring diagram braun = brown 70 μF blau = blue schw = black = red = yellow Terminal strip = green = white Weber-Unimat WT 22 - 551 13,5A excess current release Motor-Stator KRÄNZLE 115, 125, 135 230 Volt / 50 Hz Switch Weber - Amazonas 8 A for K155 KRÄNZLE 155 400 Volt / 50 Hz...

  • Page 36: General Rules

    General rules Inspections The machine must be inspected according to the “Guidelines for Liquid Spray Devices” at least once every 12 months by a qualified person, to ensure that continued safe operation is guarateed. The results of the inspection are to be recorded in writing.

  • Page 37: Ec Declaration Of Conformity

    Art. 13, High-pressure water jet machines Appendix 3, part B, chapter 27 Sound power level measured: K115-125: 87 dB (A); K135-155: 89 dB (A) guaranteed: K115-125: 89 dB (A); K135-155: 91 dB (A) Applied specifications and EN 60 335-2-79 / A1:2004...
  • Page 38 Notes Notes Notes Notes Notes...
  • Page 39 Notes Notes Notes Notes Notes...
  • Page 40 Reprint only allowed with the authorization of As of date of 10. 12. 2008...

This manual is also suitable for:

K135K155K125

Table of Contents

Save PDF