Operating Elements; Items Supplied; Commissioning; Setting The Time - Silvercrest KH 1159 Operating Instructions Manual

Injury hazard
• Keep batteries away from children. Children can
put batteries into their mouths and swallow them.
If a battery is swallowed, medical assistance
must be sought immediately.
• Should a battery leak, avoid making contact to
the leakage with your skin, eyes and mucous
membranes. If contact is made with the battery
acids, rinse the affected area with copious
amounts of water and then consult a doctor.

Operating Elements

q
Battery compartment
w
Display
e
Mounting for suspension
r
T-SET button (Timer/Clock adjustment)
t ▼ UNIT button (Unit adjuster)
y
▲ Z/T button (ZERO/TARA)
u
ON/OFF button
i
Glass plate
o
Bowl

Items supplied

• Kitchen scales
• Bowl
• 2 x CR 2032 Lithium batteries
• 2 x Screws
• 2 x Plugs
• Operating Instructions

Commissioning

➩ Open the battery compartment
the operating panel.
➩ Remove the protection strip from the battery
q
compartment .
➩ Close the battery compartment cover, until it locks
in place.
The scale is now in clock mode and ready for use.

Setting the time

On commissioning and on a change of batteries the
time must be set resp. adjusted.
➩ As soon as the batteries have been inserted the
hour indicator blinks. Press either the ▲ Z/T
or the ▼ UNIT
and set the hour indicator.
➩ Press the T-SET button
minute indicator.
➩ Press either the ▲ Z/T
repeatedly to adjust and set the minute indicator.
➩ Press the T-SET button
The time display is now programmed.
If you need to re-adjust the time display (e.g. for
Summer/Winter Time) press and hold the T-Set
button
as described above.

Wall mounting

➩ Find a suitable position for the wall assembly.
There must be sufficient space to fold down the
glass plate
may also have to be placed on the glass plate
Attention!
Check to ensure that there are no power cables
located in the wall. Should you bore into a power
cable with the drill, you may receive a potentially
fatal electric shock!
Do not drill into areas where electric cables and
gas or water conduits are, or may be, located!
➩ Using a 6mm drill, bore two holes with a horizontal
spacing of ca. 88 mm into a vertical wall.
➩ Insert the plugs into the holes and then screw in
the screws until the screwheads project by about
q
at the rear of 3 - 4 mm.
➩ Place the scales onto the screw heads using the
mounting
- 3 -
t
button repeatedly to adjust
r
to switch over to the
y
or the ▼ UNIT
r
.
r
until the hour indicator blinks. Then proceed
i
. Bear in mind that the bowl
e intended for this purpose.
y
t
button
o
i
.