Listening To The Radio; Adjust [Settings] Mode Settings; Using The Remote Controller (Rc-405); Direct Access Tuning - Kenwood KDC-MP102U Instruction Manual

Listening to the radio

1 Press SRC to select "TUNER."
2 Press (BAND) repeatedly to select a band (FM1/ FM2/ FM3/ AM).
"F1" / "F2" / "F3" / "AM" appears on the display.
3 Press 4 / ¢ to search for a station.

Adjust [SETTINGS] mode settings

While listening to the radio...
1 Press the volume knob to enter [FUNCTION] mode.
2 Turn the volume knob to select [SETTINGS], then press to enter.
3 Turn the volume knob to make a selection, then press to confirm.
See table below for selection.
4 Hold to finish the procedure.
Item
SEEKMODE Selects the tuning mode for 4 / ¢ buttons.
AUTO1 *: Automatically search for a station. ; AUTO2: Search in the order of the stations in the preset memory. ;
MANUAL: Manually search for a station.
A-MEMORY <Y>/ N *: Automatically starts memorizing 6 stations with good reception. ; Y /<N>: Cancels (automatic
memorizing is not activated). (Selectable only if [TYPE NML] is selected for [PRESET].) (page 6)
MONO SET MONO ON: Improve the FM reception (but the stereo effect may be lost). ; MONO OFF *: Cancels (stereo effect
resumes).

Using the remote controller (RC-405)

Direct Access Tuning

1 Press FM+ / AM– to select a band.
2 Press DIRECT to enter Direct Access
Tuning mode.
"– – – –" appears on the display.
3 Press the number buttons to enter the
frequency.
4 Press 4 / ¢ ( + ) to search for the
frequency.
Hold for about 2 seconds to memorize the current station.
Press briefly to recall memorized station.
Selectable setting (Preset: *)
To cancel Direct Access Tuning mode, press
or EXIT.
If no operations is done for 10 seconds
after step 3, Direct Access Tuning is
automatically canceled.
Basic operations:
FM+ / AM–
4 / ¢ ( + ) : Searches for radio station.
1 – 6
: Selects band.
: Selects preset station.
7