Components And Controls - Eastwood MIG 175 Assembly & Operating Instructions

uNPAcKING
When unpacking your Eastwood MIG175, check to make sure all of the parts listed below are included:
• MIG175 Welder
• Torch / Gun Cable Assembly
• Spool Gun Assembly
• Ground Cable Assembly
• Gas Flow Regulator
• Gas Hose
• Hand Held Shield
• Wire Brush
• 2lb Spool of 0.030" (0.8mm) Solid Steel MIG Wire
• 1lb Spool of 0.030" (0.8mm) 4043 Aluminum Wire
• 2 Contact Tips
• Contact Tip Wrench
• Instructions
• DVD

cOMPONENTS AND cONTROLS

1. Ground Cable Access Hole
2. MIG Gun/Spool Gun Access Hole
3. Power Switch
4. Voltage Control
5. Wire Speed Control
6. Latch
7. Power Cord
8. Breaker Reset Switch
9. Shielding Gas Inlet
10. Rocker Arm
11. Pressure Adjuster
12. Guide Pipe
13. Torch Tensioner
14. Positive Terminal
15. Negative Terminal
4
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
16. Wire Tension Thumb Screw
17. Wire Spindle
18. Contact Tip
19. Nozzle
20. Ground Clamp
21. Trigger Connections
22. Drive Roller
23. MIG Torch
24. Spool Gun
25. MIG Gun/Spool Gun Selector Switch
26. Regulator