Corsair Voyager Air User Manual page 4

MAKING A WIRELESS CONNECTION
Connect wirelessly to Voyager Air from your tablet, phone, or notebook computer by turning on your drive, turning on its Wi-Fi,
then looking for "VoyagerAir" in the list of wireless networks available to your mobile device.
When you are connected wirelessly from a tablet or phone, the easiest way to access and enjoy the contents of the drive is
to use the free Voyager Air app, available for iOS and Android devices. You can also use a third party SAMBA-compatible file
manager utility to connect to the drive. Or you can use a web browser.
Note: When you are connected wirelessly to the Voyager Air it has the IP address 192.168.77.1
WIRELESS PASSWORD
It is STRONGLY suggested that you enable password protection for your Voyager Air. After launching the app (or web browser
client), navigate to the Settings screen, look for the "Password:" setting, press the "Enable" button, then enter a password. The
password needs to be 8 to 63 letters long, with no spaces or special characters. That password will then be required to make a
wireless connection to the drive.
If you have enabled a Wi-Fi password but do not remember it, you can follow these steps to reset the password:
1. Make sure the Voyager Air drive is turned on.
2. Turn the drive over and locate the small hole on the bottom (near the rear).
3. Insert a paperclip into the hole, press and release. This will reset the Wi-Fi password.
Note: This reset will not impact anything stored on the drive. It only disables the wireless password setting.
3
PART 1 – OVERVIEW