Table of Contents
Advertisement
Quick Links
Trends PA-10/PA-10.1D
Tube Headphone/Pre Amplifier
Version 1.0
USER GUIDE
Trends PA-10/PA-10.1D User Guide
Copyright Notice
Copyright © 2006 ITOK Technologies Limited, All rights reserved.
All rights in this publication are reserved and no part may be reproduced without the
prior written permission of the publisher. The contents of this publication are believed
to be correct at the time of going to press, but any information, specifications, products
or services mentioned may be modified, supplemented or withdrawn without further
notice.
Trademarks
Trends, Trends Audio, and ITOK are the trademarks owned by ITOK Technologies
Limited
All other trademarks are the property of their respective owners.
ITOK Technologies Limited
Rm. K, 11/F, Kwun Tong Industrial Centre, Phase 1
472-484 Kwun Tong Road, Kowloon, Hong Kong
Tel
: +852 2304 0730
Fax
: +852 2566 5740
Email
: sales@TrendsAudio.com
Website : www.TrendsAudio.com
Advertisement
Table of Contents
Related Manuals for Trends Audio PA-10
Summary of Contents for Trends Audio PA-10
-
Page 1: User Guide
Tube Headphone/Pre Amplifier Trademarks Version 1.0 Trends, Trends Audio, and ITOK are the trademarks owned by ITOK Technologies Limited USER GUIDE All other trademarks are the property of their respective owners. ITOK Technologies Limited Rm. -
Page 2: Table Of Contents
Please take note the following instructions before installing your Trends PA-10/ TABLE OF CONTENT..................- 3 - PA-10.1D Tube Headphone/Pre Amplifier, they will enable you to get the best 1. SAFETY INSTRUCTIONS................- 4 - performance and prolong the life of the product. -
Page 3: Features
PC/iPod - Input from PC/Mac/iPod/iPad/Smartphone with higher gain by RCA-RCA cable. Output - To any line level input on your amplifier by RCA-RCA cable (PA-10.1D); CD/DAC - Input from CD/DAC by RCA-RCA cable (PA-10). Output - To any line level input on your amplifier using audio cable(2RCA-2RCA). -
Page 4: Hints And Tips
Frequency response: 15 Hz - 100 kHz -1db The sound of Trends PA-10 will open up after about 5 minutes of warm-up. At Input Impedance: 100k Ohms least half an hour of warm-up, if you are doing some audiophile listening THD+Noise 0.05% @ 10k ohm... -
Page 5: Troubleshooting
· Warranty Card x1 PA-10.1D, or R3/13(L/R channel) of PA-10) for tuning the DC bias voltage of each channel. The DC bias has been tuned in factory. But after run-in for a period or changed another tube, it would be deviated that the fine-tuning is needed. -
Page 6: Regulatory Compliance
Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the A(R) [red] and turning the screw on the top of the R6 of PA-10.1D or R13 of receiver is connected.
Need help?
Do you have a question about the PA-10 and is the answer not in the manual?
Questions and answers