Related Manuals for Pioneer KEH-P1015
Summary of Contents for Pioneer KEH-P1015
- Page 1 KEH-P1015 This product conforms to new cord colors. Los colores de los cables de este producto se conforman con un nuevo código de colores. As cores dos cabos deste produto conformam com um novo código de cores.
-
Page 2: Table Of Contents
Contents Connecting the Units ........ 2 Installation ..........5 DIN Front/Rear-mount ........5 DIN Front-mount ..........5 Installation with the rubber bush Removing the Unit DIN Rear-mount ..........7 Installation using the screw holes on the side of the unit... -
Page 3: Connecting The Units
Connecting the Units Note: • This unit is for vehicles with a 12-volt battery and • When this product’s source is switched ON, a negative grounding. Before installing it in a recre- control signal is output through the blue/white ational vehicle, truck, or bus, check the battery lead. - Page 4 Connecting the Units IP-BUS cable Rear output This Product Multi-CD player (sold separately) IP-BUS input (Blue) Fuse Antenna jack Blue/white To system control terminal of the power amp or Auto-antenna relay control terminal (max. 300 mA 12 V DC). Yellow To terminal always supplied with power regardless of ignition switch position.
- Page 5 Power amp (sold separately) Connecting cords with RCA pin plugs (sold separately) System remote control White Gray Front speaker ≠ ≠ White/black Gray/black Right Green Violet Rear speaker ≠ ≠ Green/black Violet/black Rear speaker ≠ ≠ Fig. 2...
-
Page 6: Installation
Installation Note: • Before finally installing the unit, connect the • If installation angle exceeds 30° from horizontal, wiring temporarily, making sure it is all connect- the unit might not give its optimum performance. ed up properly, and the unit and the system work (Fig. -
Page 7: Removing The Unit
Removing the Unit (Fig. 5) (Fig. 6) Frame I nsert the release pin into the hole in the bottom of the frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.) Fig. -
Page 8: Din Rear-Mount
Installation DIN Rear-mount Installation using the screw holes on the side of the unit 1. Remove the frame. (Fig. 7) Frame Insert the release pin into the hole in the bottom of the frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.) - Page 9 2. Fastening the unit to the factory radio mounting bracket. (Fig. 8) (Fig. 9) Select a position where the screw holes of the bracket and the screw holes of the head unit become aligned (are fit- ted), and tighten the screws at 2 places on each side. Use either truss screws (5 ´...
- Page 10 TEL: (03) 9586-6300 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R OP2, Canada TEL: (905) 479-4411 PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. San Lorenzo 1009 3er. Piso Desp. 302 Col. Del Valle Mexico, D.F. C.P. 03100 TEL: 5-688-52-90 Published by Pioneer Corporation.