Page 1
Z min i-Series Z 40 He a d p h o ne Ampl i fi er Owner’s Manual CD/DAC TUNER Z 40 HEADPHONES ww w.myryad.co .uk...
Page 2
WALL SOCKET, TO PROVIDE ISOLATION. ONE OR OTHER OF THESE CONNECTIONS MUST BE • The Smart My-Link® input can be connected to a Myryad CD player and Tuner – for example - which READILY ACCESSIBLE WHEN THE APPARATUS IS IN USE.
Network Audio streamer to these sockets. voltage setting printed on the rear panel is the same Alternatively, a Myryad DVD player or any other line as your local mains supply. Plug the female (socket) level source may be connected to this input.
Myryad products, unselected source products may the unit is to be operated using a remote control be switched to standby after 10 minutes by Myryad’s handset. Where possible it is best to arrange that the Power Save Mode – see “System Operation with IR window is in “line-of-sight”...
It one Smart My-Link® equipped “Control Amplifier” will also control Myryad’s Integrated Amplifiers, like the Z40, or a Preamplifier) Myryad products Preamplifiers, CD Players, Tuners and DVD Players. equipped with Smart My-Link® have a number of See the MSR3 System Remote Owner’s manual for...
• Interconnect cable pulled loose or making poor contact. Check and, if necessary, un-plug and re-plug all relevant cables. Loud buzz or hum: • Interconnect cable pulled partially out of its socket. • Defective interconnect cable. For further help please visit Myryad website at www.myryad.co.uk...
SPECIFICATIONS Maximum output level 32Ω load ≥ 4 Vrms (0.5 W) 600Ω load ≥ 8 Vrms (107 mW) Gain High +14 dB +4 dB Input impedance 20kΩ Frequency response (20Hz – 20kHz) ±0.1dB THD (1 Vrms output) <0.001% Signal-to-Noise ratio High gain 106 dB (A weighted, ref.
Need help?
Do you have a question about the ZMINI Z40 and is the answer not in the manual?
Questions and answers