Advertisement
Installation and Operating Instructions
Model: FTE10
Model: FTE16
Model: FTE20
_________________________________________________________________________________________________________________________________________________
Products comply with the European Safety Standard EN60335-2-40 and the relevant parts of the European Standards for Electromagnetic Compatibility (EMC) EN55014, and
EN61000 along with EN62233 covering Electromagnetic Field (EMF) requirements. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
_________________________________________________________________________________________________________________________________________________
10L
Dehumidifier
16L
Dehumidifier
20L
Dehumidifier
08/52826/0 Issue 0
Advertisement
Table of Contents
Related Manuals for Dimplex FTE10
Summary of Contents for Dimplex FTE10
- Page 1 Installation and Operating Instructions Model: FTE10 Dehumidifier Model: FTE16 Dehumidifier Model: FTE20 Dehumidifier 08/52826/0 Issue 0 _________________________________________________________________________________________________________________________________________________ Products comply with the European Safety Standard EN60335-2-40 and the relevant parts of the European Standards for Electromagnetic Compatibility (EMC) EN55014, and EN61000 along with EN62233 covering Electromagnetic Field (EMF) requirements. These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC.
-
Page 3: Safety Information
SAFETY INFORMATION Please read the operating instructions carefully before using your dehumidifier for the first time and keep them in a safe place. Never immerse the appliance in water or other liquids. Never operate the appliance if a cable or connector has been damaged, after appliance malfunction or if the appliance was dropped or is otherwise damaged. -
Page 4: Operating Instructions
OPERATING INSTRUCTIONS 1. Control panel 2. Air outlet 3. Carry handle 4. Front panel 5. Air inlet 6. Water outlet tube (continuous use) 7. Water tank... -
Page 5: Notes And Precautions
CONTROL PLATE DESCRIPTION OPERATION INSTRUCTION Starting the unit Allow the unit to stand upright for 24hrs to let the compressor stabilize before first use or when transported. 1. Firstly, turn the humidity control switch to the “OFF” position. 2. Plug in the dehumidifier. 3. - Page 6 3. The following table indicates the approximate relative humidity settings against its related position number on the humidity control switch: CONTROL SWITCH APPROXIMATE POSITION NO. HUMIDITY SETTING Continuous running Cont. ﹪ ﹪ ﹪ ﹪ ﹪ The ideal position is around position 6- approximately 40% relative humidity The operational temperature range for this unit is 5-35°...
-
Page 7: Drainage Instruction
DRAINAGE INSTRUCTION Switch off before carrying out any of these Fig 01 operations and leave for 3 minutes before switching on again. The extracted water is collected by the water tank (set up as supplied), or can be set up to drain continuously using a PVC hose (not included) connected to a drain outlet, the drain point must be lower than the unit outlet (see details below). - Page 8 Care and Maintenance Instruction To avoid the occurrence of vibration and noise the unit should not be operated while located on any soft or uneven surface. Never insert any foreign objects into the unit through its air inlet or outlet to avoid hazard or unit failure.
-
Page 9: Specifications
SPECIFICATIONS MODEL FTE10 FTE16 FTE20 SPECIFICATION POWER SUPPLY 220-240V~50Hz POWER INPUT 250W 410W 480W RUNNING CURRENT 1.2A 2.1A 2.2A WEIGHT 11.1Kg 13.3Kg 13.7Kg MOISTURE REMOVAL 10 litre/day 16 litre/day 20 litre/day (@ 30 ℃ ℃ ℃ ℃ & RH 80% ）... - Page 11 Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee. Should you require after sales information or assistance with this product please go to www.dimplex.co.uk or ring our helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.).
Need help?
Do you have a question about the FTE10 and is the answer not in the manual?
Questions and answers