Oil Change Required - Fiat 500x 2016 User Manual

WHAT TO DO IN EMERGENCIES
- Forward Collision Warning (FCW) OFF Indicator
NOTE:
• The default status of FCW is "On." This allows the system to warn you of a possible
collision with the vehicle in front of you.
• The forward collision button is located on the switch panel below the Uconnect
display.
• To turn the FCW system OFF, push the forward collision button once to turn the sys-
tem OFF (led turns on).
• Refer to "Electronic Speed Control " in "Operating Your Vehicle" for further informa-
tion on Forward Collision Warning (FCW) operation and proper use.
- Liftgate Ajar Indicator — If Equipped
This indicator will illuminate when the liftgate is left ajar and not fully closed.

- OIL CHANGE REQUIRED

Your vehicle is equipped with an engine oil change indicator system. The Oil Change tell-
tale and message (Oil Change Required) will display in the EVIC/DID display for approxi-
mately 10 seconds, after a single chime has sounded, to indicate the next scheduled oil
change interval. The engine oil change indicator system is duty-cycle based, which means
the engine oil change interval may fluctuate dependent upon your personal driving style.
Unless reset, this message will continue to display each time you turn the ignition switch
to the MAR/RUN position for vehicles not equipped with Keyless Enter-N-Go, or cycle
the ignition to the ON/RUN position for vehicles equipped with Keyless Enter-N-Go. To
turn off the message temporarily, push and release the MENU button. To reset the oil
change indicator system (after performing the scheduled maintenance), refer to the fol-
lowing procedure:
Vehicles Equipped With Keyless Enter-N-Go
1. Without pushing the brake pedal, push the ENGINE START/STOP button and cycle
the ignition to the ON/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Without pushing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position.
Vehicles Not Equipped With Keyless Enter-N-Go
1. Turn the ignition switch to the MAR/RUN position (do not start the engine).
2. Fully depress the accelerator pedal, slowly, three times within 10 seconds.
3. Turn the ignition switch to the STOP/OFF position.
NOTE:
If the indicator message illuminates when you start the engine, the oil change indicator
system did not reset. If necessary, repeat these steps.
137