Cutting Operation - Hitachi CL-8800BF Instructions Manual

Preparations Before Using
Direct AC Power Source
As in the case of charging, insert power feed plug into unit socket and adaptor
plug into outlet. Wait 2 minutes and turn on switch.
Before Using
1. Remove cutting edge in direction of arrow.
2. Apply 1 drop of lubricating oil at each of the
parts of the blade marked with an arrow.
Always lubricate oil before and after use. Cutting
performance deteriorates if edge is not oiled
properly. When doing more than one haircut in
one session, clean and lubricate oil edge once
after finishing each cut.
3. Align tabs of cutting edges with the unit
guide grooves and apply cutting edges to
the unit in direction of arrow.
4. Allow the unit to operate without actually
cutting for about 10 seconds and wipe off
any excessive lubricating oil.
Tab
Guide groove of unit
- 3 -

Cutting Operation

Turn on the switch.
To install the cropped hair attachments.
1. The cropped hair attachments are available for 3mm/6mm cut and 9mm/12mm
cut.
The cutting length is indicated on the inside as well as on the side of the cropped
hair attachment.Install proper cropped hair attachment for the desired cutting length.
2. Fit the cropped hair attachment
pro-trusion into the mounting hole of
the head unit until the attachment is
snapped on.
3. To remove the cropped
attach-ment, hold the corner of the
comb part and remove in the direction
of the arrow.
Mounting hole
hair
- 4 -
Protrusion