Basic Troubleshooting; Diagnostic Flash Codes - Pride Mobility Apex Spirit Owner's Manual

(1)
(4)
(10)
32
Low Battery Voltage
The battery needs charging or there
is a bad connection to the battery.
Motor Disconnected
The motor has a bad connection.
Motor Wiring Trip
The motor has a short circuit to a
battery.
Freewheel Switch Trip
The freewheel switch is activated or the
manual brake disengagement mechanism
is operated.
Not Used
Charger Connected
The S-drive is being inhibited from driving.
Throttle Trip
A throttle trip is indicated.
Possible Control System Trip
A control system trip is indicated.
Solenoid Brake Trip
The parking brakes have a bad connection.
High Battery Voltage
An excessive voltage has been applied to
the S-drive.
Check the connections to the battery. If the connections
are good, try charging the battery.
Check all the connections and leads between the motor
and the S-drive Check the position of the freewheel switch.
Check all the connections and leads between the motor
and the battery.
Check the position of the switch or lever and all connec-
tions between the switch and the S-drive.
Inhibit 2 is active. This may be because the battery charger
is connected or the seat is not in the driving position.
Make sure that the throttle is in the neutral position before
switching on the scooter.
Make sure that all connections are secure.
Check the parking brake and motor connections. Make sure
all the system connections are secure.
This is usually caused by a poor battery connection. Check
the battery connections.
Apex Spirit