Use extreme care when operating a patient lift. This guide covers the use of the LF1050 Patient Lift. Keep in mind that the basic safety procedures included in this manual are to be used as a guide only.
In case of damage, DO NOT USE the equipment. Contact the carrier or your authorized Lumex dealer for further instructions. LF1050 Patient Lift Owner’s Manual MAINTENANCE Note: The information contained in this document is based on the latest product information available at the time of publication.
Page 6
Warning: The LF1050 Patient Lift should be used solely for transferring a patient from one object (beds, bathtubs, toilets, etc.) to another. The lift should not be used for transporting or moving any patient from one location to another location.
Note: Unless the patient lift is to be used immediately, retain boxes, containers and packing material for use in storing until use of patient lift is required. LF1050 Patient Lift Owner’s Manual FEATURES 1. Boom 2. Spreader Bar 3. Actuator 4.
4. Place the control box inside the bracket. ASSEMBLY INSTRUCTIONS 1. Raise Mast from base 3. Attach the Control Box Hanging Bracket to the Mast and tighten the nuts. LF1050 Patient Lift Owner’s Manual...
Page 9
Boom and insert pin. 7. Insert the Actuator plug into the Control Box. NOTE:Prior to using the LF1050, charge the batteries overnight. (CHARGE FOR AT LEAST 10 HOURS BUT NOT MORE THAN 12 HOURS) LF1050 Patient Lift Owner’s Manual 6.
10.Lift the user above the bed by using the hand control. 11.Pull lift away from bed. Position user over the wheelchair or chair then lower the patient onto the surface. Note: Reverse the above procedures when returning the user/patient to bed. LF1050 Patient Lift Owner’s Manual...
Page 11
9. Feed the leg sections under the thighs. 10.From between the legs, gently pull the leg section up the inner thigh. LF1050 Patient Lift Owner’s Manual 11 .Feed as much material as possible under and between the thighs. Ensure the leg sections are positioned midway under the thighs to provide good support and greater comfort.
This might shorten the life of the batteries or damage the batteries. 9. Unplug the charger first before using the lift. THE LF1050 PATIENT LIFT WILL NOT OPERATE WHILE CHARGING. IMPORTANT NOTES ON CHARGING 1. Push lift to charging location and charge the batteries with the charger provided.
The casters MUST roll and swivel freely. Lightweight waterproof grease (such as automobile lubricant) should be applied to LF1050 Patient Lift Owner’s Manual CARE AND MAINTENANCE the ball bearings of the casters every six (6) months. Apply grease more frequently if the casters are exposed to periods of excess moisture.
Inspect mounting hardware for wear Ensure that control box is firmly affixed to the mast Ensure the actuator connecting cable is tight MAINTENANCE SCHEDULE Item Inspect Inspect/ Inspect/ Inspect/adjust initially adjust adjust daily monthly LF1050 Patient Lift Owner’s Manual every 6 months...
Lift does not work. Battery indicator shows full charge. Notice “click” sound from control box when UP or DOWN button on hand control was pressed. LF1050 Patient Lift Owner’s Manual TROUBLESHOOTING Possible Cause Battery discharged Battery charger defective Battery defective...
July 4, 1975. This warranty is extended only to the original purchaser/consumer or dealer/non-consumer who does not buy for resale and to no other purchaser or transferee. Graham-Field warrants the LF1050 Patient Lift against defects in materials and workmanship as listed below:...
Page 18
(province to province). Some states (provinces) do not allow the exclusion or limitation of incidental or consequential damages, or limitation on how long an implied warranty lasts, so the aforementioned exclusion and limitation may not apply to you. LF1050 Patient Lift Owner’s Manual...
Need help?
Do you have a question about the LF1050 and is the answer not in the manual?
Questions and answers