Wave Mode Lock - CISA eSIGNO User Manual

M M M M
AINTENANCE AINTENANCE AINTENANCE AINTENANCE
( ( ( ( 6 6 6 6 ) ) ) )
S S S S O O O O
ERVICE ERVICE PERATIONS PERATIONS
ERVICE ERVICE PERATIONS PERATIONS
ESIGNO_SYSTEM_USER_MANUAL_101.DOCX
W W W W M M M M L L L L
AVE AVE AVE AVE ODE ODE ODE ODE OCK OCK OCK OCK
B B B B S S S S
ATTERY ATTERY ATTERY ATTERY TATUS TATUS TATUS TATUS
The battery status control can be done using any valid staff card; there are 2 different warning levels:
• low battery status: the LED signal gives 3 red + green blinks before lock opening;
• end battery status: the LED signal gives 12 red + green blinks before lock opening.
These warnings are also recorded into lock history as separate events with respect to the openings.
Steps to change batteries: Steps to change batteries: Steps to change batteries: Steps to change batteries:
With the proper tool, it is possible to remove the batteries holder cover as shown in figure below. 3
alkaline AA LR6 type batteries are needed.
E E E E M M M M C C C C
MERGENCY MERGENCY ECHANICAL ECHANICAL YLINDER YLINDER
MERGENCY MERGENCY ECHANICAL ECHANICAL YLINDER YLINDER
The electronic locks always have an emergency mechanical cylinder with variable key bitting.
The cylinder works with 3 different keys (number from 1 to 3):
• key number 1 must be used first;
• in case of key number 1 has been lost or has not been considered secure, key number 2 can be
used. In this case the use of the key number 1 is blocked;
• in the same way, using key number 3, key number 2 will be disabled.
Independently from the key you are using, follow this procedure:
• insert the mechanical key and turn 360° in the clockwise direction;
• rotate the knob (external handle).
69/71