Related Manuals for Tool Shop 207-1545
Summary of Contents for Tool Shop 207-1545
- Page 1 ITEM NO:207-1545 MANUAL OPERAT OR’S 6-GALLON COMPRESSOR 6 GAL PORTABLE OIL FREE AIR COMPRESSOR IMPORTANT : READ OPERATOR’S MANUAL BEFORE USING 1-888-899-0146 Toll Free Helpline:...
-
Page 2: Table Of Contents
Operating Instructions ------------------------------------------------------------------------------------- 7 Care and Maintenance ------------------------------------------------------------------------------------ 8 Troubleshooting ---------------------------------------------------------------------------------------------- 9 Exploded View / Parts List ------------------------------------------------------------------------------- 11 Warranty ----------------------------------------------------------------------------------------------------- 12 PRODUCT SPECIFICATIONS Item No. 207-1545 Pump oil free, direct drive, single stage Motor 1.5 HP Voltage/Amps/H 120/12/60 Air Tank Capacity... -
Page 3: Package Contents
PACKAGE CONTENTS PART DESCRIPTION Electric Motor & Air Compressor Pump Air Tank Tank Pressure Gauge Air Pressure Regulator Regulated Pressure Gauge Air Line Outlet Air Tank Drain Valve Pressure Relief Valve ON/OFF Switch Power Cord Handle Wheel Air filter HARDWARE CONTENTS Ø10 Washer Ø10 Spring Washer M10 Nut... - Page 4 PACKAGE CONTENTS A. ELECTRIC MOTOR: The motor is used to power the pump. It contains a thermal overload protector. If the motor overheats for any reason, the thermal overload protector will shut it down in order to prevent the motor from being damaged. AIR COMPRESSOR PUMP: The pump is used to compress the air and discharge it into the tank via the piston moving up and down in the cylinder.
-
Page 5: Safety Information
SAFETY INFORMATION This manual contains information that relates to PROTECTING YOUR SAFETY PREVENTING EQUIPMENT and is very important for you to know and understand. We use the symbols below to help you PROBLEMS recognize this information. DANGER POTENTIAL HAZARD THAT WILL RESULT IN SERIOUS INJURY OR LOSS OF LIFE WARNING POTENTIAL HAZARD THAT COULD RESULT IN SERIOUS INJURY OR LOSS OF LIFE CAUTION... -
Page 6: Preparation
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 5 minutes Tools Required for Assembly (not included): 11/16 in. -
Page 7: Operating Instructions
OPERATING INSTRUCTIONS BEFORE EACH START UP 1. Set the ON/OFF switch (I) to the O (off) position. 2. Turn the air pressure regulator knob (D) counterclockwise until it stops. 3. Attach air hose/accessories or air tools (not included) to the air line outlet (F). WARNING! Risk of bursting. -
Page 8: Care And Maintenance
CARE AND MAINTENANCE WARNING::To avoid personal injury, always shut off and unplug the unit and relieve all air pressure from the system before performing any service on the air compressor. Regular maintenance will ensure trouble-free operation. SERVICE TASK INTERVAL To prevent corrosion inside the tank, the condensation must be drained at the end of every workday. -
Page 9: Troubleshooting
TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION 1. The tank drain valve is open. 1. Close the drain valve. 2. There is a leak in the 2. Check with soapy water. Tighten or reseal leaking DO NOT OVERTIGHTEN. 3. There is a prolonged or 3. - Page 10 TROUBLESHOOTING PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION 1. Tank pressure exceeds the 1. The motor will start automatically preset pressure switch limit. when the tank pressure drops below the tank cut-in pressure. 2. The fuse is blown or the circuit 2. Replace the blown fuse or reset breaker tripped.
-
Page 11: Exploded View / Parts List
EXPLODED VIEW / PARTS LIST EXPLODED VIEW PART DESCRIPTION PART DESCRIPTION Nut M10 17-3 Rubber foot Air filter Bolt M10×20 Back shroud Drain valve Bolt M5×18 Air tank Self-tapping screw ST3.9×17 Handle Bolt M8x25 Washer Ø8 Thumbscrew Check valve Cushion pad Bolt M5x10 Regulator Lock washer... -
Page 12: Warranty
MENARDS® retail store. At its discretion, TOOL SHOP® agrees to have the tool replaced with the same or similar TOOL SHOP® product free of charge, within the stated warranty period, when returned by the original purchaser with original sales receipt.
Need help?
Do you have a question about the 207-1545 and is the answer not in the manual?
Questions and answers
what is the bolt that goes into the bottom of the regulator and into the tank