Technical Data; Approximate Cutting Rates - Pentruder CW630 Operator's Manual

Operator's Manual Pentruder CW630 HF Chain Saw – Original instructions
7 Technical Data
For technical data for the Pentruder HF‐power pack please refer to the Operator's Manual for that products.
RECOMMENDED GENERATOR SIZE
WATER FITTING
LENGTH
HEIGHT
WIDTH
WEIGHT
WATER COOLING
NOISE LEVEL
(SOUND PRESSURE LEVEL)
NOISE LEVEL
(SOUND POWER LEVEL)
VIBRATION
TORQUE
HORSEPOWER
7.1 Approximate cutting rates
MATERIAL
CONCRETE – 15 cm (6 in)
RED BRICK – 15 cm (6 in)
REBAR ‐ #4 (12 mm)
Pentruder CW630‐HF Chain Saw
See Operator's Manual for HF‐drive system.
Tema series 1800
58.5 cm (23 in)
26.5 cm (10.5 in)
24 cm (9.5 in)
15 kg (33 lbs)
Min. 4 litres (1 gallon) of cool water per minute at full power output.
Water pressure:
Min 1.5 bar (20 PSI)
Max 6 bar (90 PSI)
94 dB @ 1 m (3 ft) (Kpa=3dB)
103 dB @ 1 m (3 ft) (Kwa=3dB)
2.4 m/sec² (front handle) (Uncertainty K=1.5 m/sec²)
4.5 m/sec² (rear handle) (Uncertainty K=1.5 m/sec²)
13.0Nm (9.5 ft‐lbs)
9.0 kW (12.0 hp)
Cutting rate
12 cm/min (5 lineal in/min)
25 cm/min (10 lineal in/min)
10–20 seconds through each piece
Rebar must be encased in concrete, NEVER cut bare rebar with a Diamond
Chain.
Page 21