Related Manuals for Argos Sovereign N0E-2ET-230
Summary of Contents for Argos Sovereign N0E-2ET-230
- Page 1 User Manual Cordless Strimmer N0E-2ET-230 Read the instructions thoroughly before operating the tool and keep this manual for future reference!
-
Page 2: Technical Data
KEY INFORMATION YOU SHOULD KNOW: 1.Charge the battery for about 10 hours before using your trimmer. 2.The guard must be installed before trimmer, if not, the motor will overheat, and your warranty will not apply. 3.When replacing the line, use only 1.6 mm diameter round Nylon line-otherwise the unit may not function properly. - Page 3 repair as necessary. Do not use the trimmer if the cutting device is not secured properly or is damaged. Always check that the trimmer is in good working order. If it is not, it could endanger the user. Never operate the trimmer with damaged guards or without the guards in place;...
- Page 4 proceed as follows: · Carefully wipe the liquid off using a cloth. Avoid skin contact. · In case of skin or eye contact, follow the instructions below. The battery fluid, a 25-30% solution of potassium hydroxide, can be harmful. In case of skin contact, immediately rinse with water.
-
Page 5: Operation
ASSEMBLY INSTRUCTIONS Guard installation Figure 1 Figure 2 a. Remove two screws and washers from the guard. b. Position the motor housing with line head carrier facing up.(Figure 1) c. Slide guard over motor housing.(Figure 1) d. Install two washers 1 in the correct position.(Figure 2) e. - Page 6 STARTING 1. When starting the lawn trimmer for the first time, check that the nylon lines touch or pass over the wire cutting blade. If they are not long enough, (1). press the button (2).pull more nylon wire to lengthen.(Figure 5) 2.
- Page 7 Note: There is a spring inside the head that could easily be lost. Ensure that it is put in a safe place. Figure 8 2. Choose either OPTION 1 or OPTION 2 below for spool or line replacement. 3. Insert the line through the eyelet in the spool carrier and slide the spool into it. (Figure 9) Figure 9 4.
- Page 8 1. Insert one end of line into the hole in the spool as shown Figure 11 about 3 mm. Figure 11 2. Snugly and evenly wind the line onto the spool in the direction of the arrow on the spool (Figure 11),until the line builds up to the notches in the spool rim.
-
Page 9: Maintenance
MAINTENANCE 1. After use, remove the battery pack from the trimmer; 2. When not in use store the machine out of the reach of children; 3. Use only manufacturer recommended replacement parts and accessories; 4. Your trimmer line can dry out over time. To keep your line in top condition, store spare pre-wound spools or bulk line in a plastic, sealable bag with a tablespoon of water.
Need help?
Do you have a question about the Sovereign N0E-2ET-230 and is the answer not in the manual?
Questions and answers
need video for washer installation