Installation And Safety Considerations; Installing Multiple Switch Modules; System Reliability Guidelines; Handling Static-Sensitive Devices - Fujitsu Brocade 6545 Gen5 Hardware Reference Manual

2

Installation and safety considerations

Installation and safety considerations
This section discusses the following topics:
•
•
•
•
•

Installing multiple Switch Modules

Each Brocade 6545 16 Gbps FC Switch Module must be assigned a unique Ethernet IP address
during configuration. After the default Ethernet IP address on the Switch Module has been
changed, you can install additional Switch Modules in the PRIMERGY BX900 S2 or BX400 Blade
Servers.
If you do not have a DHCP server, install and configure one Switch Module at a time to ensure that
IP address conflicts do not occur from duplicate Ethernet IP addresses.
Refer to the PRIMERGY BX900 S2 Basic Unit Operating Manual that comes with your Fujitsu
PRIMERGY BX900 S2 or BX400 Blade Server for help identifying your specific enclosure setup,
available connections, and power requirements.

System reliability guidelines

To help ensure proper cooling, performance, and system reliability, make sure the following
requirements are met:
•
•
•
•

Handling static-sensitive devices

CAUTION
Static electricity can damage the chassis and other electronic devices. To avoid damage, keep
static-sensitive devices in their static-protective packages until you are ready to install them.
To reduce the possibility of electrostatic discharge, observe the following precautions:
•
•
12
"Installing multiple Switch Modules"
"System reliability guidelines"
"Handling static-sensitive devices"
"Electrical considerations"
"Environmental considerations"
Each of the I/O module bays at the rear of the Fujitsu PRIMERGY BX900 S2 or BX400 Blade
Server contains either a switch or a filler blade.
A removed hot-swappable Switch Module should be replaced with an identical Switch Module
or filler blade within 60 seconds of removal.
The ventilation areas on the sides of the Fujitsu PRIMERGY BX900 S2 or BX400 Blade Server
power modules and blowers are not blocked.
You have followed the reliability guidelines in the documentation that comes with your Fujitsu
PRIMERGY BX900 S2 or BX400 Blade Server.
Limit your movement. Movement can cause static electricity to build up around you.
Handle the device carefully, holding it by its edges or its frame.
Brocade 6545 Gen5 16-Gbps FC Switch Module Hardware Reference Guide
53-1003184-01