Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for AngelEye SA700-AE-UK
Summary of Contents for AngelEye SA700-AE-UK
- Page 1 Optical Smoke Alarm User Manual SA700-AE-UK www.angeleye.com...
- Page 2 Licence No: KM597992 0086-CPR-597993 Smoke alarm devices EN 14604:2005 DOP:13/02 GN3563R1 SA700-AE-UK Optical Smoke Alarm A Sprue Brand Sprue Safety Products Ltd. Vanguard Centre, Coventry CV4 7EZ UK Technical Support: 0800 141 2561 / EIRE dial 1-800 523171 Email: technicalsupport@sprue.com...
-
Page 3: Table Of Contents
CONTENTS Features Battery Replacement Positioning Troubleshooting Installation Maintenance Alarm Test Disposal Alarm Pause Warranty Note: This user manual is also available in large text and other formats Please email: technicalsupport@sprue.com or call 0800 141 2561 for further information... -
Page 4: Features
• Easy Installation - fixings supplied MINIMUM RECOMMENDATIONS POSITIONING RECOMMENDED FOR ADDITIONAL PROTECTION WARNING: Your AngelEye smoke alarm NOTE: Kitchens should be covered by a self contained heat detector. can be installed into a new build property as additional protection to an existing... - Page 5 Your in the hallway, as close as possible to the SA700-AE-UK smoke alarm can be used living accommodation In single storey in individual sleeping / resident rooms, homes with two separate sleeping areas, a...
-
Page 6: Installation
INSTALLATION Commercial and Industrial Premises This smoke alarm is not intended for any non-residential, commercial or industrial 4 Separate the alarm from the mounting application, nor for any other purpose plate This may require you to turn the than described above alarm clockwise while holding the base Mobile Homes and Caravans plate... -
Page 7: Alarm Test
Fitting / Replacing the batteries: alarm is inside the base plate twist it anti-clockwise to lock it into place a Undo the screw and remove the Test the alarm battery access door from the back of the alarm ALARM TEST When alarm is located on base unit, Press and release the test button to twist in this direction to lock... -
Page 8: Alarm Pause
WARNING: If there is any question as to WARNING: The electronic test button provides a full test of the unit’s functionality the cause of an alarm, always assume that DO NOT try to test the alarm with a naked this is due to an actual fire and follow your flame as this may present a potential fire fire emergency plans Do not assume the hazard in itself and contaminate the alarm... -
Page 9: Troubleshooting
TROUBLESHOOTING Problem Solution • If testing immediately after first activating the alarm or replacing the batteries, you should allow a few seconds for the alarm to settle before testing Your smoke alarm • Make sure you push the centre of the test button firmly does not sound during •... -
Page 10: Maintenance
MAINTENANCE Storage in low humidity, and certain transportation conditions, may cause Your smoke alarm has been designed electrostatic charges to build up in to be as maintenance-free as possible, the alarm system housing Although however there are several things you harmless, they may increase the length must do to keep it working properly of time that the horn sounds upon battery... -
Page 11: Warranty
WARRANTY Sprue Safety Products Ltd shall not be liable for any Sprue Safety Products Ltd warrants to the original incidental or consequential damages caused by the purchaser that its enclosed smoke alarm be free breach of any expressed or implied warranty Except from defects in materials and workmanship under to the extent prohibited by applicable law, any normal residential use and service for a period of 5...
Need help?
Do you have a question about the SA700-AE-UK and is the answer not in the manual?
Questions and answers