Refrigerator Model Thetford N112 Lcd (Single Axle Models); Operating Instructions; Powering With Electricity; Selecting Electrical Power - elddis Buccaneer Owner's Handbook Manual

HOW TO USE YOUR CARAVAN'S
EQUIPMENT

REFRIGERATOR MODEL THETFORD N112 LCD (Single Axle Models)

A = Main switch (on/off)
B = Mode selection switch
C = Cooling level selection switch

OPERATING INSTRUCTIONS

When the caravan is on tow, the refrigerator
should only be operated electrically, i.e. from the
12V battery in the towing vehicle and not by
means of the bottled gas.
The refrigerator can be run on 230V or LP gas
whilst stationary.
CAUTION: Only use one source of energy at a
time.
WARNING: The refrigerator should not be
operated on LP gas whilst being towed or
when on a petrol station forecourt.
Switching on the refrigerator
• Clean the inside of the refrigerator before
you switch it on.
• Let the refrigerator run for at least eight
hours before you place food in it for the first
time.
Switch settings
• direct current (DC) (12V)
• mains supply (230V)
• gas
• OFF
D = Function LED
E = LCD display

POWERING WITH ELECTRICITY

Selecting electrical power

Mains voltage (230V): The LED warns you
whenever insufficient voltage is available or if a
fault occurs. If this happens, the LED will start
flashing once per second and an error code is
shown in the LCD display. When sufficient
current is available again, or the fault has been
resolved, the LED will emit a steady blue light
again.
Direct current (12V): The LED warns you
whenever your vehicle's engine is not running, or
if a fault occurs, or if sufficient voltage is available.
If this happens, the LED will start flashing once
per second and an error code is shown in the
LCD display. Once the engine is running, or the
fault has been resolved, or sufficient voltage is
available again, the LED will again emit a steady
blue light.
NB: If the refrigerator has been manually set to
operate at 12V, it will not automatically switch to
another energy source when your vehicle's
engine is not running. In this case, the refrigerator
will stop cooling.

POWERING WITH GAS

Selecting gas operation
If the flame cannot be lit within 30 seconds, the
gas supply will stop and gas mode will be
switched off. The LED will start flashing every
second and an error code is shown in the LCD
display.
9-4