GENERAL OPERATING INDEX INSTRUCTIONS MACHINE PARTS ..............15 Carefully read the instruction manual IMPORTANT SAFEGUARDS ............16 and warranty limitations. USING THE ESPRESSO MACHINE ............16 The machine must be connected to a INSTALLATION OF THE ESPRESSO MACHINE .........16 grounded power outlet. CLEANING THE ESPRESSO MACHINE ............16 The machine must be kept clean by frequently TROUBLESHOOTING ................16 washing the grill, the drip tray, the capsule holder,...
MACHINE PARTS TEMPERATURE INDICATOR LIGHT CAPSULE HOLDER (indicates the machine status) (for “Metodo Iperespresso” capsules) MAIN ON/OFF SWITCH CUP HOLDER COFFEE BREW BUTTON INTERNAL BEEPER (starts and stops coffee fl ow) (emits an audible signal to the user) COFFEE BREW HEAD POWER CORD TRAY FULL FLOAT STEAM WAND...
- The appliance is only to be installed in locations where it can IMPORTANT SAFEGUARDS be overseen by trained personnel. - To reduce the risk of injury, do not drape cord over the When using electrical appliances always follow the safety pre- counter top or table top where it can be pulled on by children cautions below.
In case of damage or malfunction, turn off the appliance and do not tamper with it. For repairs contact a service center au- thorised by the manufacturer and request the use of original spare parts only. Failure to comply with these instructions may compromise safe operation of the machine and will result in the forfeiture of warranty rights.
MAKING COFFEE The X7.1 machine is designed to function exclusively with illy “Metodo Iperespresso” capsules. The icons in the circle will light up progressively to indicate the increase in the boiler temperature.
- Press the coffee button and keep it pressed until the coffee has reached the desired level. Release the button. The ma- chine is now programmed. MANUAL MODE - to set the machine to work in the manual mode, carry out the following steps: - Insert a capsule into the capsule holder and then fi...
When the machine reaches the Note: The two end parts of the steam wand can also be washed right temperature, the button in a dishwasher; in this case also remove the inside part from will light up. the metal tube. After cleaning, fi t the inside part X all the way onto the steam wand;...
Press the steam button for at Keep the steam button pres- least 3 seconds. sed down for 3 seconds. A programmed quantity of hot wa- ter will be dispensed; the fl ow will The machine will start dispensing stop automatically. hot water;...
Page 10
That is, the machine must be run through a rinse cycle; carry out the following steps: - Remove the tank and clean it thoroughly; fi ll it with 1 litre of fresh water (up to the MAX level). - Take out and fi ll the tank with 1 litre of water (up to the MAX 1 Liter level).
The descaling solution must be disposed of in accordance with the applicable laws and regulations. CLEANING AND MAINTENANCE The machine and its components must be cleaned at least once a week. Keep the water in the tank fresh; wash the tank and fi ll it daily with fresh drinking water.
TROUBLESHOOTING Check the mains electrical connection; check the status of the circuit breakers protecting the home You press the button but it does not electrical system. light up. Carry out the following operations: - Fill the water tank; make sure it is fi tted completely into place. - Remove the capsule holder from the coffee brew head.
RECOMMENDATIONS To enjoy a high quality espresso, remember to: Change the water in the tank at least once a week. If possible use water with a low calcium content to redu- Disposal of end-of-life electric and electronic equipment by ce scale build-up inside the machine. private households in the European Union.
Page 14
Tipo di macchina - Machine type - Type de machine - Maschinenart - Tipo de máquina - Tipo de máquina - Type toestel - Maskintype - FrancisFrancis for illy X7.1 “Metodo Iperespresso” - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - Direttive specifi...
Need help?
Do you have a question about the X7.1 Metodo Iperespresso and is the answer not in the manual?
Questions and answers