Circuit Breaker Panels (288Ss/328Ss) - Monterey 214SS Owner's Manual

Electrical System
Hatch Lifter (268SS)
Provides protection and electrical current to the
switch that controls the electric engine hatch lifter.
Bilge
Provides protection and electrical current to the
switch that manually activates the aft bilge pump.
Electronics
Provides protection and electrical current directly
to the electronics in the helm.
Acc #1
Reserved for additional 12 volt equipment.
Acc #2
Reserved for additional 12 volt equipment.
Acc #3
Reserved for additional 12 volt equipment.
Engine Main Breakers
The primary circuits for the engine is protected
by heavy duty, "push to reset" breakers on each
engine. They are supplied power whenever the
engine battery switches are on. Refer to the en-
gine owner's manual for information on the loca-
tion and operation of the engine circuit breakers.
Windlass Circuit Breaker (268SS)
A heavy duty circuit breaker that provides protec-
tion and power for windlass relay. This breaker is
supplied current when the battery selector switch
is activated. If the circuit breaker is tripped by
an overload, a red lever will be exposed near the
center of the breaker. Reset the breaker by rais-
ing the lever until it locks in the horizontal position.

6.6 Circuit Breaker Panels (288SS/328SS)

Power is distributed to most of the 12 volt acces-
sories through individual circuit breakers located
in the DC breaker panels or fuses in the power
management module for the digital switching
system. The following is a description of circuit
breaker panels and the accessories they control.
Some accessory circuit protection described in this
section is for equipment that is optional on some
models and may not be installed or available on
your boat
There are two DC breaker panels, the battery
switch breaker panel and the helm or cabin acces-
sory breaker panel located below the helm or in
the or in the cabin. Accessories activated by the
268SS Windlass Circuit Breaker
Near Starboard Battery In Engine Compartment
digital switching system in the helm are protected
by fuses in the power management module.
Main breakers located in the battery switch panel
protect the system from an overload. Some 12
volt accessories are operated directly by the circuit
breaker in the panels while others are operated
by switches fed by the panel breakers.
288SS Battery Switch Panel Breakers
The following is a description of the accessories
controlled by the "push to reset" and main DC
breakers in the 288SS battery switch panel.
Helm Main
The primary circuit for the main DC panel near
the helm is protected and powered by this circuit
breaker. Other circuit breakers located in the
main DC breaker panel protect the individual DC
circuits. This "push to reset" breaker is sup-
plied current when the HOUSE battery switch is
activated.
Stereo Amp
A "push to reset" circuit breaker that provides
SURWHFWLRQ DQG SRZHU IRU WKH VWHUHR DPSOL¿HU IRU
the boat speaker system. This breaker is sup-
plied current when the battery selector switch is
activated.
Head System
Provides protection and electrical current directly
to the electric head system.
MONTEREY
BOATS
79