Linear RJ31X Installation Instructions

RJ31X ADAPTER
FOR USE WITH
THE PERS CONSOLES
installation instructions
To provide proper telephone line seizure this cable must be connected to an 8-position telephone
jack installed per FCC Universal Service Order Code RJ-31X or RJ-38X. See Figure 1 for details
of the telephone jack wiring.
A single ended 8-conductor modular line cord is used to connect the PERS console to the
telephone jack. Plug the LINE and PHONE plugs into the appropriate jacks on the PERS console.
See Figure 2. Route the cable away from the jacks via the internal raceway. Then install the
8-position plug into the telephone company jack.

Testing

Test the PERS console by first calling the central station and informing them that a test is going
to be performed.
Trigger an alarm via the remote control or from the large EMERGENCY/HELP button on the
console.The house phones will be disconnected and the central station will recieve the emergency
message. If the console is equipped with two-way voice capability the central station may talk via
the console to verify proper operation of the two-way voice system.
After the PERS console goes offline, the house phones will be restored to normal operation.
6
5
4
TO "LINE"
3
JACK ON
2
PERS CONSOLE
1
8-PIN
MODULAR
PHONE CORD
8-POSITION
USOC RJ31-X
(OR RJ38-X)
JACK
R
T
TO TELEPHONE
NETWORK
Figure 1
Copyright © 2005 Linear Corporation
1
2
3
TO "PHONE"
4
JACK ON
5
PERS CONSOLE
6
OTHER WIRES
NOT USED
R1 R T T1
SHORTING BAR
SHORT REMOVED
ON PLUG
1 2 3 4 5 6 7 8 INSERTION
T1
R1
TO LOCAL
TELEPHONE
SETS
(760) 438-7000
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
www.linearcorp.com
Example with
PERS-2400A
ROUTE CABLES UNDER
STRAIN-RELIEF TABS
(PHONE)
CONNECT LOCAL
TELEPHONE TO
CONNECT TELEPHONE
THIS JACK
LINE TO THIS JACK
Figure 2
TELEPHONE
JACK (RJ31X
OR RJ38X)
CONSOLE WITH
REAR COVER
INSTALLED
(LINE)
221329 B