Troubleshooting - DeLonghi HCX Series Instructions For Use Manual

TROUBLESHOOTING

PROBLEM
The appliance doesn't work
The appliance doesn't work
(the display could blink
and you could hear an
intermittent "beep")
The display shows
blinking dot and you hear an
intermittend "beep"
The display shows "PF"
The display shows "Ht"
blincking (the heating
power will progressively and
automatically be reduced)
Be sure it is plugged in and that the electrical
outlet is working
The temperature may be set too low
The Key lock may be activated
The timer is not correctly programmed
The air intake or outlet grille is obstructed
a The appliance could have been tipped over or is
positioned in an improper way
The temperature sensor is malfunctioning
The internal temperature is too high
CAUSE
7
SOLUTION
Plug into the power outlet
Set the temperature higher
See the section "Key lock"
Program the timer correctly
Remove the obstruction unplug from the
mains and let the appliance cool down. After
few minutes plug in the appliance again. If
the appliance doesn't work please contact
De'Longhi Customer Experience
Make sure the appliance is standing upright
on a flat surface. Position the appliance
correctly
Contact De'Longhi Customer Experience
To remove the cause of this alarm check
that the unit is not covered or obstructed.
The appliance will operate again after a few
minutes.
Check the appliance is correctly positioned
respecting the minum distances from the
wall, or other objects, as indicated in Fig. 3,
if not, position the appliance correctly. The
appliance will operate again after a few
minutes.