Table of Contents
Advertisement
Section A - Installation Instructions
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
•
As a stand alone appliance
•
As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above
IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front and the
surface must be capable of supporting 100 lbs (45 Kg).
NOTE: A 60" (152 cm) long cable is supplied with
the Warm & Serve Drawer.
Stand Alone Installation
Minimum distance to
floor 41/2" (11,4 cm)
A. HEIGHT
B. WIDTH
9 7/ 8 " (25 cm)
30" (76,2 cm)
D. CUTOUT
E. CUTOUT
HEIGHT
8 3/ 8" (21,3 cm)
28 1/ 2 " (72,4 cm)
Min.
8 5/ 8" (21,9 cm)
28 3/ 4 " (73 cm)
Max.
Warm & Serve Drawer Dimensions
60" (152 cm)
Cord
Warm and Serve
Drawer
Warm and Serve
Cutout
FLOOR
C. DEPTH
24 5/ 8" (62,5 cm)
F. CUTOUT
WIDTH
DEPTH
24" (61 cm)
IMPORTANT: The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
Combination Warm & Serve Drawer/
30" (76 cm) Built-in Oven Installation
Caution: Two 3" wide X 3/4"
(1.9 cm) thick planks have to
be install and they should be
able to support 200 pounds.
(90.7 Kg)
H* =10 1/8" (25.7 cm) Min. is a Critical
dimension and has to be respected.
A. HEIGHT
B. WIDTH
40" (101,5 cm)
30" (76,2 cm)
D. CUTOUT
E. CUTOUT
HEIGHT
WIDTH
8 3/8" (21,3 cm)
28 1/2 " (72,4 cm)
Min.
Max.
8 5/8" (21,9 cm)
28 3/4 " (73 cm)
3
C. DEPTH
24 5/ 8" (62,5 cm)
F. CUTOUT
G. HEIGHT
DEPTH
24" (61 cm)
1 1/2" (3,8 cm)
Depends on critical
dimension H
Advertisement
Table of Contents
