Searching For Active Channels Within A Group (Active Channel Scan); Adjusting The Monitor Audio Level - Sony UWP-D11 Operating Instructions Manual

3
Press the + button.
The tuner starts to scan through the selected channel
group. When available channels are found, the first
channel number among the available channels starts
flashing on the display.
To display the next available channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the CLR
SCAN menu.
4
Press the SET button when the desired channel
number starts flashing.
The search for available channels finishes and the
displayed channel is set.
The channel setting is transmitted from the infrared
transmission port for about ten seconds after setting
the channel. During this interval, place the infrared
detector on the transmitter (with the power turned on)
near the tuner to transfer the channel setting from the
tuner to the transmitter.
To scan channels automatically when
power is turned on
With the tuner power off, press and hold the SET button
and press the POWER button for at least one second to
turn the power on and to automatically start a clear
channel scan.
Searching for active channels
within a group (Active Channel
Scan)
Procedure for portable diversity tuner (URX-P03)
You can search for channels in use within the specified
channel group. This is useful when using more than one
tuner in combination with a single transmitter.
Before performing this procedure, select the channel
group.
For details, see "Setting the receive channel" (page 21).
1
Use the + or – button to display the ACT SCAN
menu.
22
Tuner Settings
2
Press and hold the SET button for one second or
longer.
Press and hold until the channel group and "+"
display starts flashing.
3
Press the + button.
The tuner starts to scan for active channels in the
selected channel group. When active channels are
found, the first channel number among the active
channels starts flashing on the display.
To display the next active channel number
Press the + button.
To cancel searching
Press the – button. The display returns to the ACT
SCAN menu.
4
Press the SET button when the desired channel
number starts flashing.
The search for active channels finishes and the
displayed channel is set.

Adjusting the monitor audio level

Procedure for portable diversity tuner (URX-P03)
You can set the monitor audio level within the range 1 to
16.
1
Use the + or – button to display the PHONES menu.
The current monitor audio level is displayed.
2
Press and hold the SET button for at least one second.
Press and hold until the monitor audio level flashes.
3
Use the + or – button to set the desired monitor audio
level, then press the SET button.
The setting value is stored. The setting is retained
even after the power is turned off.