(standard output of 500 mV), set to the NORMAL position. For use with an RCA GM-A3602 equipped Pioneer car stereo, with maxi- Front side mum output of 4 V or more, adjust level to match that of the car stereo output.
! Despite correct volume and gain settings, the unit sound still cuts out periodically. In such cases, please contact the nearest authorized Pioneer Service Station. Gain control of this unit Preout level: 2 V (Standard: 500 mV)
Please see the following section for speaker connection instructions. Refer to Connections when using the speaker input wire on page 8. a Fuse 30 A × 2 (GM-A5602) / 25 A × 1 (GM- A3602) b Fuse (30 A) × 2...
Speaker channel Power na, antenna cable and tuner. Nominal input: Two-channel output Min. 150 W (GM-A5602) Min. 60 W (GM-A3602) About bridged mode Nominal input: One-channel output Min. 450 W (GM-A5602) Min.
Connecting the units One-channel output work with some headunits. In such cases, please use a system remote control wire (sold sepa- rately). If multiple amplifiers are to be connected together synchronously, connect the head unit and all amplifiers via the system remote control wire.
Connecting the units 5 Insert the O-ring rubber grommet into the 4 Terminal screws 5 Battery wire vehicle body. 6 Drill a 14 mm hole into the vehicle body. 6 Ground wire 7 System remote control wire Twist the battery wire, ground wire and system remote control wire.
Page 8
Connecting the units 1 Terminal screws 2 Speaker wires 3 Speaker output terminals...
3 Floor mat or chassis down until it has cooled to a certain desig- 4 Hole-to-hole distance: 338 mm (GM-A5602) / nated temperature. 228 mm (GM-A3602) ! Place all cables away from hot places, such 5 Hole-to-hole distance: 196 mm (GM-A5602) / as near the heater outlet.
Grounding system ....Negative type Current consumption .... 14.5 A (at continuous power, 4 W) Average current drawn ..4 A (4 W for two channels) 6.5 A (4 W for one channel) Fuse ..........25 A × 1 CAR STEREOS PIONEER AUDIO SYSTEMS...