Link Procedure (T14Sg/R7008Sb) - FUTABA 14SG S.Bus2 Instruction Manual

Link procedure (T14SG/R7008SB)

Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver
must be linked with the ID code of the transmitter with which it is being paired. Once the link is made,
the ID code is stored in the receiver and no further linking is necessary unless the receiver is to be used
with another transmitter. When you purchase additional R7008SB receivers, this procedure is necessary;
otherwise the receiver will not work.
Link procedure
1. Place the transmitter and the receiver close
to each other within half (0.5m) meter.
Less than 0.5 m
2. Turn on the transmitter.
3. Select [SYSTEM] at the Linkage menu and
access the setup screen shown below by
touching the RTN button.
:You can do this through the LINKAGE Menu
and scroll to System and press RTN.
4. When you use two receivers on one model,
you must change from [SINGLE] to [DUAL].
*Only t wo rec e i ve rs c a n b e u se d. I n
"DUAL", two setting items come out. Input,
respectively.
ID of a Primary
receiver displays.
In DUAL, a primary receiver
i s l i n k p r e v i o u s l y . N e x t , a
secondary receiver is link.
5. "F" will be chosen if it is used in France. others
"G" general.
6. When changing battery fail-safe voltage
f r o m t h e i n i t i a l v a l u e 3 . 8 V , v o l t a g e i s
changed here.
* Only in FASSTest Mode.
7.[LINK] is chosen by scrolling and the RTN
button is pushed. The transmitter will emit a
chime as it starts the linking process.
8. When the transmitter starts to chime, power
on the receiver. The receiver should link to
the transmitter within about 1 second.
In "Link" Mode
ID of a Secondary
receiver displays.
9. If linking fails, an error message is displayed.
Bring the transmitter closer to the receiver
and repeat the procedure above from Step 2.
10. ACT will be chosen if telemetry is used.
It is INH when not using it.
Receiver ON
<Basic Operation> 37