Koolbreeze P12HCP Climateasy 12 User Manual

Koolbreeze P12HCP Climateasy 12 User Manual

Portable air conditioner 3.5kw (12000 btu/hour)

Advertisement

Climateasy 12
Portable Air Conditioner
3.5kW (12000 BTU/hour)
Model Number P12HCP
Air Conditioning
Heating
Cooling
Dehumidifying
Remote control
3 Fan speeds
LED display panel
24 Hour timer
Page 1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the P12HCP Climateasy 12 and is the answer not in the manual?

Questions and answers

Summary of Contents for Koolbreeze P12HCP Climateasy 12

  • Page 1 Climateasy 12 Portable Air Conditioner 3.5kW (12000 BTU/hour) Model Number P12HCP Air Conditioning Heating Cooling Dehumidifying Remote control 3 Fan speeds LED display panel 24 Hour timer Page 1...
  • Page 2: Before Use

    IMPORTANT Installer and Users please note: These instructions should be read carefully and left with the user of the product for future reference. BEFORE USE Inspect the product including its cable and plug for any signs of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately.
  • Page 3 Slide the two-part window adaptor to the correct length to fit the window. Close the window as far as possible to keep the window adaptor in place. Clip the fish-tail shaped adaptor into the aperture in the window adaptor. Keep the hose as straight as possible, avoid dips where the moisture from the exhaust air can condense and fill the tube with water.
  • Page 4: General Safety Requirements

    The hose can be expanded up to 1.8 m long, but the shorter it is the more efficiently the CLIMATEASY 12 will operate. Do not extend the hose, or replace with another type of hose. Remote Control Fit one lithium 3V battery to the remote control, observing the correct polarity.
  • Page 5: Product Safety

    PRODUCT SAFETY  This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. ...
  • Page 6 CONTROLS REMOTE DISPLAY PANEL Page 6...
  • Page 7: Operation

    OPERATION Leave the appliance in an upright position for 3 hours before first use. Plug the mains lead into a 13 Amp mains socket (unless permanently installed) If connecting via an extension lead, make sure that the lead is rated at 13 Amps or more, and that it is fully unwound. Switch the unit on at the mains socket.
  • Page 8 Heating mode: heats if the room is temperature is below the selected temperature. Then use the TEMP+ and TEMP- buttons to select the desired room temperature. When the temperature reaches the desired temperature, the compressor will stop, and the fan will continue to run. Heating performance reduces if the outdoor temperature falls below 7 °C "SPEED"...
  • Page 9: Using The Timer

    The water should be disposed of down a drain. To avoid the need to empty the water, a permanent drain tube may be fitted as shown: use a piece of 18mm diameter tube (not supplied) and run the pipe to a drain, making sure that it runs downhill all the way.
  • Page 10: Using The Remote Control

    USING THE REMOTE CONTROL The heating, cooling, dehumidifying and fan modes are selected in exactly the same way as using the control panel on the main unit. Page 10...
  • Page 11: Maintenance

    MAINTENANCE Before cleaning, turn the appliance off, and disconnect from the mains supply. The appliance may then be cleaned using a damp cloth with a drop of washing-up liquid to remove any dust or dirt from the case. Do no use stronger detergents or solvents as these may damage the plastic.
  • Page 12: Fault Finding

    FAULT-FINDING If the CLIMATEASY 12 is not operating, proceed as follows: Check that the mains plug is firmly in the socket, and that the socket is switched ON. When the unit if switched on there will be a delay of about 1 minute before it starts to operate.
  • Page 13: Fault Codes

    FAULT CODES If any error codes appear on the display, contact your local service agent. E0: Open circuit or short circuit in room temperature sensor. END OF SEASON STORAGE. Before putting the appliance into storage, empty all water from the drain, and run the appliance on "fan only" mode fo a few hours to dry the inside thoroughly.
  • Page 14: Technical Specification

    If you have any problems with this product, please in the first instance call the retailer from whom you purchased it. Koolbreeze Division Cottage Stores LLP Claverdon Cottage...

Table of Contents