Software Upgrade Procedure For Cpc-96 And Cpc - Panasonic DBS 576 Technical Manual

Introduction to DBS 576 Programming

Software Upgrade Procedure for CPC-96 and CPC-288

Introduction
1. Power-off the system.
2. On the CPC card, take note of the current
0
System
Configuration
FF1
System
3. Insert the PC Card into the slot on the PC
FF2
Trunks
4. Plug the PC Upgrade Kit into the special
FF3
Extensions
5. Power-on the system.
FF4
FF-/Soft Keys
FF5
Groups
6. Power-off the system again.
7. Unplug and remove the PC Upgrade Kit from the CPC card.
FF6
TRS/ARS
8. On the CPC card, set the CODE rotary switch back to the position it was in before
9. On the CPC card, press and hold down the MODE button, then power-on the
FF7
Applications
FF8
Maintenance
10. On the CPC card, press the RESET button.
Appendix A
Appendix B
Page Intro-12
arrow position on the CODE rotary switch
(you' ll be setting it back to this position after
the upgrade). Then turn it to:
"2" for New Software Release or
•
"4" for Software Upgrade.
•
Upgrade Kit, with the PC Card' s label facing
up.
connector (CN3) on the edge of the CPC-96
or CPC-288 card. The connectors are shaped
so that the Upgrade Kit can plug-in only one
way. (It is not necessary to remove the CPC
card to do this.)
The "MN" LED on the CPC card will
•
fast-blink for a few minutes while the
system' s Flash ROM is upgraded.
When the upgrading is complete, the
•
"MN" LED will extinguish.
the upgrade.
system. Keep holding the MODE button down until the "MN" LED starts flashing
red. The following events should occur in this order:
The "MN" LED will intermittently flash red. (Release the MODE button.)
•
The "RUN" LED will flash red.
•
The "MN" LED will stop flashing.
•
On installed display phones, "Welcome to DBS" will display.
•
After a few seconds, the system will power itself off, then back on.
•
All display phones should show the normal menu at idle.
•
DBS 576 (USA) issued January 1999
Section 400: Programming
The CPC-288 Card
(front edge, facing out from cabinet)
CN3
(for PC Upgrade Kit)
RUN LED (FPU)
RUN LED (MPU)
MJ LED
MN LED
RAM HOLD switch
RESET button
CODE rotary switch
MODE button
MOH plug-in
576-20-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B