Seq - Dell S4810 Reference Manual

Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Usage
When all sequence numbers have been exhausted, this feature permits re-
Information
assigning a new sequence number to entries of an existing access-list.

seq

Assign a sequence number to a deny or permit filter in an extended IP access list while creating the filter.
S4810
Syntax
seq sequence-number {deny | permit} {ip-protocol-number | icmp
| ip | tcp | udp} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator port
[port]] [count [byte] | log] [dscp value] [order] [monitor]
[fragments]
Parameters
sequence-
number
deny
permit
ip-protocol-
number
icmp
ip
tcp
udp
source
mask
any
host ip-address
Access Control Lists (ACL)
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter a number from 0 to 4294967290. For the S4810 , the
range is from 0 to 65534.
Enter the keyword deny to configure a filter to drop packets
meeting this condition.
Enter the keyword permit to configure a filter to forward
packets meeting this criteria.
Enter a number from 0 to 255 to filter based on the protocol
identified in the IP protocol header.
Enter the keyword icmp to configure an ICMP access list
filter.
Enter the keyword ip to configure a generic IP access list.
The keyword ip specifies that the access list permits all IP
protocols.
Enter the keyword tcp to configure a TCP access list filter.
Enter the keyword udp to configure a UDP access list filter.
Enter an IP address in dotted decimal format of the network
from which the packet was received.
(OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject
to the filter.
Enter the keyword host and then enter the IP address to
specify a host IP address or hostname.
243