Creating The Server Accessible Lun Groups (Setting The Lun Groups); Table 2.4 Transfer Rate Setting Values (For Fabric Connection) - Fujitsu ETERNUS DX60 S3 Configuration Manual

Chapter 2 Setting Up the ETERNUS DX
2.1 Common Settings
Parameter
Transfer Rate
Frame Size
Reset Scope
Release Reservation if Chip is Reset
*1: Set the appropriate value from the following table.

Table 2.4 Transfer Rate setting values (for Fabric connection)

Fibre Channel switch maximum
speed
16Gbit/s
8Gbit/s
4Gbit/s
*1: Specify "Auto Negotiation" for direct connections to 16Gbit/s Brocade Fibre Channel cards.
Make sure to prepare and set up Fibre Channel switches for Fibre Channel connections. For setting details,
refer to "FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (Fibre Channel) Fibre Chan-
nel Switch Settings" or "Fabric OS Administrator's Guide Supporting Fabric OS".
2.1.2

Creating the Server Accessible LUN Groups (Setting the LUN Groups)

Create LUN groups for the server to access. Refer to "Connectivity Management" in "ETERNUS Web GUI User's
Guide" for details, and set the LUN groups.
Depending on the OS version, the server may not recognize the ETERNUS DX unless a LUN group is as-
signed from LUN0. In this case, assign a LUN group starting from LUN0 in ascending order.
Transfer rate setting value
16Gbit/s CA
16Gbit/s (*1)
8Gbit/s
4Gbit/s
9
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
Setting value
See the table below (*1)
2048
I_T_L
Disable
8Gbit/s CA
8Gbit/s
8Gbit/s
4Gbit/s
P3AM-7962-08ENZ0