Remarks "*" in the Preventive Maintenance Check List
*1 Original glass
Clean both sides of the original glass.
Note: Make sure that there is no fingerprints or oil staining on part of the original glass on where the original
scale is mounted since the shading correction plate is located below the scale to be scanned.
*2 Slit glass
Take off the skit glass unit and clean the face side and back side of the glass.
*3 Pickup roller and feed roller
When installing the pickup roller and feed roller, pay attention to allocate the pickup roller, gear, feed
roller and one-way clutch correctly.
*4 Separation roller
When replacing the separation roller, replace only the roller and continue to use the torque limitter.
JUNE 2002 © TOSHIBA TEC
(1)
(2)
Slit glass
Gear
Idler gear
shaft
Torque
limitter
Separation roller
Feed roller
4 - 13
Cleaning face
Pickup roller
One-way
clutch
e-STUDIO550/650/810 PREVENTIVE MAINTENANCE