Sony PVM-L2300 Operation Manual page 47

Menu
Contrast Hold
Auto
Auto Adjust
Target Color Temp
x
y
Function and operation ([
Sets whether or not to adjust the color temperature and contrast (backlight) at the same time.
Off: Contrast is adjusted.
[On]: Contrast is not adjusted.
Adjusts the color temperature automatically by using an optional probe.
When the item is selected, the color temperature data to be adjusted is displayed.
When D93 or D65 data is changed, they are displayed as D93* or D65*.
When Contrast Hold is set to Off, the color temperature data and contrast data are displayed.
The contrast data is displayed as the picture preset data Preset1 to Preset5 set in Picture
Preset of the Input Configuration menu, or MANUAL. To change the displayed data from the
picture preset data to MANUAL, set the MANUAL button of CONTRAST to on. To change the
displayed data from MANUAL to the picture preset data, set the MANUAL button of
CONTRAST to off. To change the type of the picture preset data, select from Preset1 to
Preset5 in the Picture Preset menu of the Input Configuration menu.
For information about the Input Configuration menu, see page 50.
Starts adjustment.
When Auto Adjust is selected, not only the target color temperature but also other color
temperature data are adjusted, as the color temperature of the backlight is calibrated in
accordance with the color temperature of Target Color Temp.
When Contrast Hold is set to Off, the contrast data are also adjusted, as the backlight is
calibrated in accordance of the luminance of Target Luminance.
Note
This menu is not selectable in the following case:
• When DVI Computer or the computer signal of HDMI is selected in the Format menu of the
Input Configuration menu
Before automatic adjustment, select the value to use for the adjustment in following
sequence.
When you use the previously adjusted values for adjustment, select Auto Adjust to start
adjustment without performing step 1, step 2 and step 3.
1 Select the color temperature to be used in Target Color Temp.
When Any is selected, enter the values of the CIE color system x and y coordinates.
2 When Contrast Hold is set to Off, select Target Luminance and enter the value of the
2
luminance (cd/m ) when the 100% white signal is input.
3 Select the probe to be used in Probe.
4 Select Auto Adjust.
The following message appears.
Set probe on cursor.
Attach the probe on the center of the display to start automatic adjustment. (It may take
some time until the automatic adjustment is completed.)
Note
First select the probe and then select Auto Adjust.
To cancel/stop the adjustment
Press the MENU button.
Sets the adjustment value to be used from D93, D65 or Any.
Enters the CIE color system x coordinate.
Set to 0.280 to 0.345.
Enters the CIE color system y coordinate.
Set to 0.280 to 0.352.
]: factory setting)
47
Adjustment Menu