Start-Up; Placing; Inserting The Batteries; Providing Mains Power - Silvercrest KH 2336 Operating Instructions Manual

Start-up

Placing

• Remove the MP3 CD Player and accessories
from the packaging.
• Remove all transport restraints and adhesive
tape/films.
Important:
Do not permit small children to play with plastic
packaging. There is a risk of suffocation!
• Place the MP3 CD Player on a level horizontal
surface. Place the MP3 CD Player in such a way
that the lid of the CD compartment is able to fully
open. At the same time the carrying handle must
be folded backwards.

Inserting the batteries

If you wish to operate the MP3 CD Player with
batteries you must disconnect the mains power
cable from the device. For battery operation you
will require 6 x 1.5 V batteries of the type C/LR
(Batteries not supplied).
• Open the battery compartment on the rear panel
of the device.
• Place the batteries into the battery compartment
observing the polarity as depicted there.
• Carefully close the battery compartment cover
again until the cover locks into place.

Interaction with batteries

Leaking batteries can cause damage to the
MP3 CD Player.
• If you do not intend to use the MP3 CD Player
for an extended period of time, remove the batteries.
• Always change all batteries at the same time
and always use batteries of the same type.
• Do not attempt to recharge the batteries and
always insert batteries/power pack with the
correct polarity. The possibility of explosion
exists if the batteries are not replaced properly.
• Should the batteries leak, wear protective gloves
and clean the battery compartment with a dry
cloth.

Providing mains power

• Insert the plug of the mains cable into the mains
cable connection on the rear panel of the device.
• Insert the plug of the power cable into a wall
power socket.
The MP3 CD Player detects when the mains cable
is connected and automatically switches to mains
power operation.

General operation

Turning the device on/off, selecting
sound source
You switch the device on by selecting, with the
functions switch, a sound source:
• CD/MP3
• RADIO
1.
Slide the function switch to the position of your
desired sound source. The power LED lights up.
2.
To switch the device off again slide the function
switch to the "OFF" position. The power LED
goes out.

Adjusting the volume.

You can adjust the sound volume with the volume
regulator.
• To increase the volume turn the volume controller
in a clockwise direction.
• To reduce the volume turn the volume controller
in a counter clockwise direction.

Using headphones

You can connect to the MP3/CD player with radio
headphones with a 3.5 mm stereo jackplug. The
headphones connection is located on the left side
of the MP3 CD Player. When you have connected
the headphones, the loudspeakers are disconnected
and you will only hear sound via the headphones.
- 35 -