Table of Contents
Advertisement
2.
Maintain labels and nameplates on the product. These carry important safety
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
Measurement Range
Accuracy
Response Time
Distance to Spot Size
Battery Requirements
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
read the entIre Important safety InformatIon section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
note: Do not expose this product to strong electromagnetic fields, such as those
generated by an arc welder, induction heater, etc. Allow the unit 30 minutes to
adjust, before use, when introduced to significant temperature changes.
1.
Remove the battery cover and insert a 9V battery into the unit, paying attention to
polarity. Replace battery cover.
2.
Push the "Laser ON/OFF" button to activate unit.
3.
Pull and hold down trigger to turn unit on. When the Trigger is released, the unit
will beep and display the last temperature measured for 15 seconds.
4.
To locate a "hot spot" move laser up and down in an area to see temperature
variance.
5.
Non-reflective surfaces will yield a more accurate reading than reflective
surfaces. Duct tape (not included) can be applied to reflective surfaces in order
www.daihoaphu.com, email: daihoaphu@vnn.vn, tel: 08.62591090
SKU 96451
saVe these InstructIons.
specIfIcatIons
-4° F to 968° F
(-20° C to 520° C)
± 4° F below 212° F
± 2% reading above 212° F
500 mSec
8:1
9V
unpacKIng
operatIng InstructIons
for technical questions, please call 1-800-444-3353.
AVOID EXPOSURE – Laser light is emitted from this aperture.
DANGER
LASER LIght
AVOID DIREct EyE EXPOSURE
Max. Output: <5 mW, Wavelength: 630-660 nm
Class IIIa laser ProduCt
this product complies with 21 CFr 1040.10 and 1040.11
CeN-teCH, 3491 Mission oaks Blvd., Camarillo, Ca, usa, 93011
WARNINg
to prevent serious injury:
1.
do not use for medical purposes.
2.
Wear aNsI-approved safety goggles when replacing battery.
DO NOt REMOVE.
date:_____, _________________
reV 07j
Page 3
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 96451 and is the answer not in the manual?
Questions and answers