Download Print this page

Gioteck VX-1 Quick Setup

VX - 1 QUICK SETUP

1. Connect the VX-1 to your console via its charging lead.

2. Insert the usb dongle into a usb port on the console.

3. The LED on the dongle will flash quickly (slow flashing is

receiving mode not pairing mode).

4. Immediately press the home button on your controller.

5. All the LEDs on the controller will flash, and after a short

time one (or two) will remain solid.

6. Immediately disconnect the charging lead from the

controller and the LEDs will flash again.

7. Repeat steps 4 & 5. (Sometimes pushing the home button

again will speed up this process. If the controller fails

to respond, repeat the process but make sure that you

disconnect the dongle and reinsert.)

8. To add multiple controllers (up to 7) or assign your

controller to a different port go to:

Accessory settings > Reassign controller.

Table of Contents

Need help?

Do you have a question about the VX-1 and is the answer not in the manual?

Page 1 VX - 1 QUICK SETUP 1. Connect the VX-1 to your console via its charging lead. 2. Insert the usb dongle into a usb port on the console. 3. The LED on the dongle will flash quickly (slow flashing is receiving mode not pairing mode).
Page 2 Important Notices: • Make sure that the battery is fully charged before first use. • For the first few weeks your controller may need more frequent and longer periods on charge. • Use of the vibration feature will shorten the gaming time. •...