Husqvarna 250 PS Workshop Manual page 35

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
8
Check the big end of the piston rod. Replace the
crankshaft if there are signs of seizing or discoloration on
the sides.
The piston rod should not show any noticeable radial
play (up and down movement) although sideways play is
acceptable.
Check the small end of the piston rod. Replace the
crankshaft if there are signs of seizing or discoloration on
the bearing surface.
Assembly
Clean all components before assembly. Fit the casing
bearings onto the crankshaft.
NOTE! It is important that the bearings are drawn tight
up against the crankshaft.
Heat the drive side of the crankcase and pull in the
crankshaft using fitting tool 502 50 30-12.
35
www.mymowerparts.com