Table of Contents
Advertisement
DX Air Curtain
SETTING display
1
Displayed during setup of the timer etc.
Operation mode select display
2
The selected operation mode is displayed.
CHECK display
3
Displayed while the protective device works or
a trouble occurs.
Timer time display
4
Time of the timer is display.
(when a trouble occurs, the check code is
displayed).
Timer SET IN setup display
5
When pushing the Timer SET IN button, the
display of the timer is selected in order of
[OFF]
[ON]
No display.
Filter display
6
If "FILTER
" is displayed, clean the air filter.
TEST run display
7
Displayed during a test run.
Louver position display
8
Displays louver position.
SWING display
9
Displayed during up/down movement of the
louver.
Set up temperature display
10
The selected set up temp. is displayed.
Remote controller sensor display
11
Displayed while the sensor of the remote
controller is used.
PRE-HEAT display
12
Displayed when the heating operation starts or
defrost operation is carried out.
While this indication is displayed, the indoor fan
stops.
[OFF] repeat OFF timer
No function display
13
Displayed if there is no function even if the
button is pushed.
Air volume select display
14
The selected air volume mode is displayed.
(AUTO)
(HIGH)
(MED.)
(LOW)
Louver Number display.
15
(example:01, 02, 03, 04)
Dry operation in self cleaning function
16
Displayed during dry operation in self cleaning
function.
Power saving mode display
17
Displayed during capacity saving mode by
temporary peak-cut limiting the power current
level of the outdoor unit.
Louver lock display
18
Displayed when there is a louver-locked unit in
the group (including 1indoor unit by 1outdoor
unit).
Unit Number display
19
Unit number of the indoor unit selected with the
unit select button or abnormal indicate the
indoor/outdoor unit.
Central control display
20
Displayed when the air conditioner is used
under the central control in combination with a
central control remote controller. In case the
remote controller is disabled by the central
control system,
operation is not accepted. Even when you push
ON/OFF, MODE, or TEMP. button, and the
button operation is not accepted. (Settings
made by the remote controller vary with the
central control mode. For details, refer to the
Owner's Manual of the central control remote
controller.)
29
Owner
flashes. The button
Advertisement
Table of Contents
